Part Number: TMCS-A-ADAPTER-EVM Hi
Please provide the CE/EU Declaration of Conformity for SKU TMCS-A-ADAPTER-EVM?
This is not found on the T.I website.
Thank you
Part Number: TLV320AIC3254 Tool/software: Hi,
I have a custom board with the schematics at this thread below, the tlv320aic3254 is controlled by an MCU over I2C.
https://e2e.ti.com/support/audio-group/audio/f/audio-forum/1401532/tlv320aic3254-tlv320aic3254…
Part Number: TMCS1126 Tool/software: In the instructions (SBAU452) it says:
But in the data sheet:
In the DS, GND is pin 9 and Vs pin 4, not 8 and 3 as shown in the user guide.
I am going to assume that the data sheet is correct!
Part Number: USB-PD-CHG-EVM-01 Other Parts Discussed in Thread: BQ25798 , TPS25751
Tool/software:TPS25751 、BQ25798
I prepared two batteries (single-cell 4.2V each) for a simple charging test. I’ve already switched to JP1 and used the following bin file…
Part Number: MMWCAS-DSP-EVM Other Parts Discussed in Thread: AWR2243 , MMWCAS-RF-EVM , Tool/software: Hi, Experts!
[cascade_radar_object_detect] usecase of PROCESSOR_SDK_RADAR_03_08_00_00 is being used, AWR2243 MMWCAS-RF-EVM and companion MMWCAS-DSP-EVM…
Part Number: BQ25798 Other Parts Discussed in Thread: TPS25751
Tool/software:
Hi all,
For our embedded gaming system, we plan to use a 3s battery pack to power the system. We must charge the battery with a USB adapter and we need to configure the charger…
Part Number: BQ25792 Tool/software: I have designed a custom BMS circuit using BQ25792 (the Schematic is attached as a PDF) to charge 3S Li-ion Battery Pack, and the Input Power Source connected to the BMS(through VAC1) is a 12V Adapter(NOT A USB).
…
Part Number: TCAN334 Other Parts Discussed in Thread: TCAN3414 Tool/software: Hello experts,
We are using the TCAN334 (soon we will switch to the TCAN3414) along with the 6432 IWRL radar chip. Our device seems to work robustly alone on a network with…
Part Number: BQ25798 Other Parts Discussed in Thread: BQ24133 Tool/software: Hi,
I use a BQ25798 with adapter and 1S battery. The VPMID is configured to be 7V.
The usercase is that the device works on battery (without adapter). This case works well …
I have replaced TPS with TPS25751, and it now works as expected thanks to your advice. Regarding the previous issue with RE: TPS25750: non-PD adapter after first connection latched BQ25713 that no usb connection can charge there is new problem of charge…