Part Number: TMDXIDK5718 HI,
I am working on the TMDXIDK5718 board with processor sdk version 06_03_00_106
As per requirement of my project I need to boot the uboot using uart or code composer studio but according to the processor sdk version 06_03_00_106…
Part Number: TMDXIDK5718 Other Parts Discussed in Thread: AM5718 Hi,
I am using am5718 idk and my SDK version is 6.03.00.106 Linux. I want use a pin to gpio then how can I change the dts file related to that. Explain with an example.
Regards,
Bhardwaj…
Hi Mounika,
Parth Nagpal said: Also, there are some standard test cases available at /opt/ltp that you can try.
As I mentioned there are some test cases available at the path above, but apart from that you'll have to write your own test cases. Regards…
Ryan Sorry for the delayed response here.
Ryan Hodgman said: Wanted to check if there was any update on the Sync1 Start Time Register issue at startup?
In this case, can you check when does the master update SYNC1 Cycle Time (0x09A4-0x09A7) register? Is…
Part Number: TMDXIDK5718 Hi,
I'm using SDK-LINUX-AM57X 06_03_00_106 on TMDXIDK5718.
I want to connect to 10BaseT hub by using Eth2.
Eth0 and Eth1 work well, but Eth2 - 5 don't work.
"ethtool" shows Eth2 - 5 are not supported.
Please…
Part Number: TMDXIDK5718
Hi, I am working on TMDXIDK5718 board
Can I get the procedure to flash the board through sdcard or through Code Composer Studio IDE
Part Number: TMDXIDK5718 Hi,
How can i use industrial sd card consists of test casesand linux sd card consists of MLO and Uboot which came with am571x _idk evm board
Regards,
Mounika
Part Number: TMDXIDK5718 HI,
i have installed SDK version as specified below : https://software-dl.ti.com/processor-sdk-linux/esd/docs/06_03_00_106/linux/Overview_Building_the_SDK.html#introduction
i have installed CCS IDE 9.3 version because it is supported…
Hi Mounika,
Addressed a very similar topic on this thread: https://e2e.ti.com/support/processors-group/processors/f/791/t/1137606
This should help you out.
Regards Karthik