Hi,
This post appears to be on the same issue as this post: https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1413095/tms320vc5402-the-system-does-not-switch-to-hpi-boot-mode . Therefore, I will close this post and continue the discussion…
Hi Maruyana,
Apologies for the delayed response. Can you provide some additional details:
You mention 1 out of 80 devices fail. Is this out of 80 total units, or is the 1.25% failure rate extend across a larger quantity of units, and if so, how many…
Part Number: TMS320VC5402 Tool/software: Hello everyone at TI.
1. When powering up the TMS320VC5402PGE100 DVDD, please tell me the time that the RS (reset) signal on pin 98 should be low.
Would 30 clocks or more be sufficient?
2. After powering up…
Part Number: TMS320VC5402 Hi
My customer want to get TMS320VC5402PGER10's package information.
In HP, we coud not see information.
https://www.ti.com/product/TMS320VC5402/part-details/TMS320VC5402PGER10
May I get the information?
Thanks,
GR
Part Number: TMS320VC5402 Dear Sir or Madam.
Please could you tell me the terminal finish of the part TMS320VC5402.
Please could you inform me about the thickness of Au in case the terminal finish is NiPdAu or NiAu or Au.
Thanks in advance.
Best Regards…
Part Number: TMS320VC5402 Hello,
my team needs to migrate a very old project developed with CCS 2.21 to a newer version of Code Composer.(3.1, 3.3 or 5.3). We have a Spectrum Digital XDS510USB emulator
Is there an application report as your SPRACR4A? …
Part Number: TMS320VC5402 What are the differences between the following part numbers? I don't see anything in the data sheet that explains what is different about the part or packaging for these ordering codes.
TMS320VC5402PGE100
DSG5402PGE100
…
Hello,
There is no information available on this read/write cycles or derating with temperature. All information for this product would be in the ti.com product page.
Thank you,
Anita
Part Number: TMS320VC5402 Hi all,
I am investigating on a failed board in the production. The design is pretty old and the production is quite big, we hade few hundred of this board. In one of them, I am not able to program it correctly.
So I have two question…