Hi Huseyin,
Cortex R4/5 does not support interrupt nesting inherently. If you do need nested interrupts it needs to be managed completely by the application code. There is no hardware mechanism to aid with this other than the pending interrupt status…
Hi Konstanty,
Please refer attached FEE user guide to get clarification for your doubts:
1234.TI FEE User Guide.pdf
If your doubts not clarified even after referring the user guide then i will answer them for you.
-- Thanks & regards, Jagadish…
Hi Sebastian,
Regarding more details about 8Sec erase time you can refer below thread:
(+) TMS570LS1227: Data flash erase times - Arm-based microcontrollers forum - Arm-based microcontrollers - TI E2E support forums
Sebastian Schöler said: => The…
Part Number: RM57L843 Other Parts Discussed in Thread: LAUNCHXL2-RM57L , LAUNCHXL2-570LC43 , HALCOGEN Tool/software: Code Composer Studio Dear Experts,
I try to debug my code which run on the LAUNCHXL2-RM57L kit. But I can not get the value of "temp…
Hi Surya,
Can you please refer FEE User Guide? Your most of the questions will get answered by this user guide.
3386.TI FEE User Guide.pdf
Let me know if you have any further doubts after referring above user guide.
--
Thanks & regards, Jagadish…
Hello,
I've been trying to get the SCI2 module on a TMS570LC43x HDK to work for quite some time now. However, I am getting no response from the Tx (pin T5) or Rx (pin P4) pins.
I've tried the following:
1) Sending a Tx signal: pin remains low. …
Hi,
If you use bank 7 as EEPROM to store block of data, you can use TI FEE driver to write data to and read data from the EEPROM . The FEE driver is generated by HALCoGen if FEE is checked, because it was already tested and it is reliable
The TI FEE…
Hi, Please refer attached user guide of FEE, which contains everything you needed to get start with Emulated EEPROM.
--
Thanks, Jagadish. 1425.TI FEE User Guide.pdf
Hi @ Bartosz Nowicki
The emulated EEPROM is divided into two or more Virtual Sectors. Each Virtual Sector is partitioned into several Data Blocks. A Virtual Sector can contain one or more contiguous physical flash sectors. A minimum of 2 Virtual Sectors…
Hi Vimal,
The emulated EEPROM is divided into two or more Virtual Sectors. Each Virtual Sector is partitioned into several Data Blocks. A Virtual Sector can contain one or more contiguous physical flash sectors. A minimum of 2 Virtual Sectors are required…
