Part Number: TMS570LS1227 Other Parts Discussed in Thread: HALCOGEN Hi,
I am developing a custom board with TMS570LS1227ZWT and Phy DP83848 in RMII configuration.
i was able to set up the emac driver and send raw packets without any stack and receive…
Part Number: TMS570LS1227 Tool/software: Hi, I need to develop a hardware test to validate the read and write operations of memory on the device. Could you please confirm which specific regions of the available memory can be safely read and written during…
Part Number: TMS570LS1227 Other Parts Discussed in Thread: HALCOGEN Hi,
I am encountering an issue with the GIO module in code generated using HALCoGen. Specifically, when I set Output 5 to a high state (1), it appears that other registers are being…
Part Number: TMS570LS1227 Hello,
Looking at the datasheet for our device, table 6-28 states that the minimum EMIF clock period is 11 nanoseconds which equates to 90 MHz.
Before I saw this in the datasheet, I configured the EMIF to run at 180 MHz and…
Part Number: TMS570LS1227 Tool/software: We are executing ECC diagnostic testing on the TMS570LS1227 (Rev C) using Diagnostic Mode 1 on BUS2 only , following the standard procedure documented in the TRM (SPNU515C, Section 5.6.2 and 5.7.26–5.7.27):
…
Part Number: TMS570LS1227 Other Parts Discussed in Thread: DP83640 , , HALCOGEN Tool/software: Hello,
for a custom project I am trying to interface a DP83848 with TMS570LS1227. I chose the DP83848 instead of the DP83640 since it is AEC-Q100 certified…
Part Number: TMS570LS1227 Tool/software: Hello TI Team,
We are using the TMS570LS1227 microcontroller in our aerospace program. This device includes two flash banks, BANK0 and BANK7. According to the reference manual, BANK7 is intended for EEPROM emulation…
Part Number: TMS570LS1227 Other Parts Discussed in Thread: TMDS570LS12HDK , HALCOGEN Tool/software: Hi,
I use an evaluation board tmds570ls12hdk with TMS570LS1227 microcontroller.
I need to read the results (ADC) from the 'Results’ Memory by accessing…
Part Number: TMS570LS1227 Hi,
I am experiencing something that I don't believe is described in the device datasheet or Technical Reference Manual. My EMIF reads are about half the speed of my EMIF writes with the same number of wait states applied to…
Part Number: TMS570LS1227 Tool/software: Hi,
I am seeking clarification regarding the ADC reading conversion results in continuous mode for the TMS570LS1227 microcontroller. - What is the recommended procedure (sequence) for reliably reading conversion…
