Part Number: TMUX1119 Other Parts Discussed in Thread: DP83630 , Tool/software: We are using a TI DP83630 external PHY in RMII master mode, which produces a 50MHz REF_CLK.
That 50MHz REF_CLK has to be switched or multiplexed with another signal so they…
Part Number: TMUX1119 Tool/software:
Who is pin 1?
I would have assumed the line is the pin 1 marker. The DVM suggest that this is not correct.
Is the sloped side the pin 1 marker?
Part Number: TMUX1119 Tool/software: Hi team,
Dimension of tape and reel of SOT-23 is smaller than package size.
Could you please provide correct dimension information of SOT-23?
Best regards,
Shota Mago
Part Number: TMUX1119 Tool/software: Hello,
Please share "TMUX1119DCKR" turn on and turn off time as it doesn't mention into its datasheet.
Thanks,
Krunal
Part Number: TMUX1119 I am using the TMUX11119 with this config:
- square signal 0-5V with F= 1.3KHz connected to the S1 pin
- SEL pin connected to a GPIO (0-3V3) with F=50KHz
- 1K load conected to D pin
I attached a scope with:
Yellow: Output…
Part Number: TMUX1119 Other Parts Discussed in Thread: TMUX2889 Hello,
We are looking for a SPDT switch which enable Analog EMG path to battery Charging path (5V, 600mA) in a wearable device.
Looking for a SPDT switch IC, which needs to meet the…
Part Number: TMUX1119
Dear Team,
I am using TMUX1119DCKR in one of my projects.
My I/P is S1=3.6V and S2 is 1.8V.In our lab circuit, I/P is provided from a Power analyzer from Keysight.( https://www.keysight.com/in/en/product/N6705B/dc-power-analyzer…
Part Number: TMUX1119 When simulating TMUX1119. People advice add big resistor to ground. Simulation works with resistors, but result is not wright. How you can add two TMUX1119 following each other.
Part Number: TMUX1119 Other Parts Discussed in Thread: TS5A9411
Hi,
I got a question on power consumption of muxes like TS5A9411, TMUX1119 when active.
Static power consumption stated in datasheet is low, but what is the right figure for total…
