Part Number: TPD1E0B04 Tool/software: WEBENCH® Design Tools Please provide the Si simulation model of the device(PD1E0B04DPLR),Thanks!
email: piguanghui@semptian.com
Part Number: TPD1E0B04 Dear Sir/Ms.
May I have S parameter model & spice model of TPD1E0B04DPLR? My customer ask that for PCIE Gen 4 simulation.
Best Regards,
Kami Huang
Back to Interface Home Page
UART Protection
Highlights:
Lower speed serial data transfer interface
Operating lines: GND, ±TX, ±RX
Datalines (±Tx, ±Rx) Operating voltage: 3.3V, recommended Vbr > 3.6V
Data rates up to 5…
Part Number: TPD1E0B04 Other Parts Discussed in Thread: TPD1E01B04
Dear Sir/Ms.
Is air discharge only 9kV?
Competitor's spec.
I check CL value with other vender's product.
For example. Murata LXES03AAA1 CL Lower then TPD1E0B04DPLR.
https:…
Part Number: TPD1E0B04 Dear Sir/Ms.
My customer search for PCI-E Gen 4 ESD protect. I search ESD product. TPD1E0B04DPLR is the lowest Cj and low cost in 1 bit ESD but The data sheet does not indicate protection that can be used in PIC-E Gen4.
Dose TPD1E0B04DLPR…
Part Number: TPD1E0B04 Other Parts Discussed in Thread: CC1310 , , TPD1E1B04 Hello,
I am working with CC1310 with 433MHz frequency.
In my design i have external antenna and i want to provide ESD protection for that.
Can i use TPD1E0B04 for antenna ESD protection…
Hi,
RF_P and RF_N are the most sensitive to an ESD strike especially if the ESD over-voltage was on the antenna. Due to the physical size of the antenna, it unfortunately takes the largest hit when receiving an over-voltage; which then goes to the RF_P…
Other Parts Discussed in Thread: PSPICE-FOR-TI Back to FAQ Home Page
Interface Protection Guides
Part Recommendation
Packaging & Layout
Models
Transient Standards
System/Device Level Design
Power Dissipation and Temperature
Top…
Hi Ali,
This is ESD Diode we use on our RF line and all reference designs but can also be used on any lines.
TPD1E0B04DPY: https://www.ti.com/product/TPD1E0B04
Best regards,
Bun