Hi Eli,
No we don't. If the RF line is exposed, for example through a connector, a low-cap ESD diode is recommended close to the connector. TPD1E0B04 is a good alternative.
Regards,
Fredrik
Hi Francisco,
While we don't have an ESD protection device on our CC2530 reference design, you could use the ESD protection device we use on the CC1352P-4 device, found here:
https://www.ti.com/product/TPD1E0B04#order-quality
Best,
Nate
Other Parts Discussed in Thread: PSPICE-FOR-TI Back to FAQ Home Page
Interface Protection Guides
Part Recommendation
Packaging & Layout
Models
Transient Standards
System/Device Level Design
Power Dissipation…
Stacey,
We have the TPD4E02B04 that’s can support it. Or you can use the one channel solution that we have of the TPD1E01B04 or TPD1E0B04.
Also you can check out our ESD selection guide here
Regards,
Cameron
Tamio,
There is no discussion at this time of passing TPS3701 for ESD testing IEC61000-4-2 standard. There are external ESD protection devices that can be added to the above circuit to pass IEC61000-4-2 standard.
An example of an ESD device you…
We don't do recommendations on how to do ESD protection on the board since this is a system level task. A design using a PCB antenna where no part of the PCB is exposed will require less ESD protection than a design where "everyone" can touch the design…
Hi,
After looking into this a bit, we have a few products that may be suitable. Please find the recommended parts below in the order described. Not all protections are available for the required breakdown voltages, such as EFT for the TPD4EUSB30
…
Mitch,
What interface is this device for?
We have the TPD4E02B04-Q1 that is a 4 channel automotive device that could fit. The single channel low cap devices automotive qualified are in our roadmap.
If you do not need auto qualified the TPD1E0B04…
