Part Number: TPD1S514 Tool/software: Dear Specialists,
My customer is considering TPD1S514 and has a question.
I would be grateful if you could advise.
---
I think the total loss of the TPD1S514 needs to take into account not only its own current…
Part Number: TPD1S514 Datasheet mentions "Precision clamp circuit limits the Vbus_sys voltage < Vovp" There are no specifications on this clamping voltage in the datasheet. Figure 12 show that Vbus_sys shuts off during an overvoltage event. Is this IC…
Part Number: TPD1S514 Hi team,
Do we have such device that could meet the need from customer? I want to recommend the TPD1S514,but the Vcon seems not to meet the customer need.
最小供电电压[VDD(Min.)]
<-10V (can withstand -10V surge)
最大供电电压…
Part Number: TPD1S514 Hi Team,
If the customer are not using the VBUS_PWR out, it is necessary to load the 1uF cap and keep it floating? Thank you.
Best regards,
Mike
Part Number: TPD1S514-2EVM Other Parts Discussed in Thread: TPD1S514 , BQ24074 Hi,
Could someone review my TPD1S514 schematic please?
I think it's OK but I'd just like confirmation.
I've configured it in "always on" mode and so I've not connected…
Part Number: TPD1S514 Hi experts,
customer want to know the VBUS_CON resistance value to the ground when EN pin in disable and enable status, can we help to provide?
Resistance
EN DISABLE
EN ENABLE
VBUS_CON to GND
? Ω
? Ω
…
Part Number: TPD1S514 Hi team,
Thanks for your support.
I want use TPD1S514 to protect VBUS Protection, I have some concern with it,please help to confirm.
1.If the voltage on the VBUS is 6~8V, Does the TPD1S514 damage?
2.Does TPD1S514 have current…
Joern,
I am going to move this thread to TI thinks resolved because I haven't received the information necessary to evaluate generation of the Spice Model for this part.
Regards,
Chuck
