Part Number: TPD3E001 Hi Team,
A customer would like to confirm if the TPD3E001DRSR is approved to use on a medical device classified as medical class II.
Regards,
Danilo
Part Number: TPD3E001 Hi team,
My customer is developing below circuit. They use 2 MUX devices to switch one SPI interface to 2 connectors. The 2 connectors will be connected to some external modules so the 2 connectors need to endure hot swap. So I think…
Part Number: TPD3E001 Other Parts Discussed in Thread: ADS1292 , ADS1298 , , ADS1292R Hello TI application engineer, (forward Ticket CS0318282 , support by TI Danilo R. Austria Jr. Texas Instruments Customer Support)
-------------------------- we have an urgent…
Part Number: TPD3E001 Dear TI,
Below is the whole schematic applying TPD3E001DRL related to this matter.
Here, when the RA7 is applied, the status of the USB OTG ID signal is as shown below, This shows that VBUS is flowing backward or leaking into the ID…
Other Parts Discussed in Thread: TPD3E001 E2E Team,
I have a customer that is interested in using the TPD3E001 device in their design. They have some questions regarding implementing this device on some of their USB connections on their products.
Are…
We are using the TPD3E001 for ESD protection of USB signal pairs.
Now we want to use the part for ESD protection of Gigabit Ethernet pairs.
However the ethernet circuit is a passive PoE injector with only 12 V available as VCC.
Do we need to connect to…
Other Parts Discussed in Thread: TPD3E001 I am using three TPD3E001 in DRY-6 package on my design and the data sheet doesn’t show any marking for pin1.
As Murphy’s law strikes, the CM had 50% chance to put them the wrong way, which of course he did…
Other Parts Discussed in Thread: TPD3E001 Hi,
I am using the TPD3E001 to protect D+/D- of a high speed USB port. I chose the 3 port device instead of the 2 port as the pinout worked better for my routing.
My question is what should I do with the un-used…
Part Number: ESD122 Other Parts Discussed in Thread: TPD3E001 , TVS0500 Hello experts,
I have question about ESD protection device connection for USB2.0.
In ESD122 datasheet, it is connected with IO line and GND line in below.
Also, in TPD3E001 datasheet…