Part Number: TPD3S714-Q1 Other Parts Discussed in Thread: TPD3S713-Q1 , TPD3S713A-Q1 Tool/software: Do we have a UL certification available of
TPD3S714-Q1
https://www.ti.com/product/TPD3S714-Q1
TPD3S713-Q1
https://www.ti.com/product/TPD3S713-Q1…
Part Number: TPD3S713A-Q1 Other Parts Discussed in Thread: TPD3S716-Q1 , Tool/software: Hello,
I have some ESD related questions for the TPD3S713A-Q1. In comparison with a similar USB protector TPD3S716-Q1 you are not suggesting using a CMC or inductor…
Part Number: TPD3S713A-Q1 Hello Team,
About the CS pin of TPD3S713A-Q1,
Is it dynamic or fixed compensation?
If dynamic,how to choose the DCDC feedback resistor R(FA)?
If fixed,I can choose the R(FA) according to the actual compensation voltage…
Part Number: TPD3S713A-Q1 Other Parts Discussed in Thread: TPD3S713-Q1 Hello Team,
There is no mention whether the TPD3S713A-Q1 can work in OTG mode in the datasheet,
If we need to download software by this USB port, whether it's OK?
Thank you!
Part Number: TPD3S713A-Q1 Hello Team,
The description below which means we must connect the BUS pin to the USB connector in client mode,correct?
And the peripheral must input 5V VBUS to the device?
Thank you!
Part Number: TPD3S713A-Q1
I haven't seen a lot of information about I-MON. The recommended value is 2.55k. Can I connect to 2.2k? Is the formula as shown in the figure? Can this PIN be floating if not used?
Why is the pull-up resistance of BIAS always…
Part Number: TPD3S713A-Q1 Hello Team,
About pins ILIM_LO and ILIM_HI ,
if I float the ILIM_HI and set the resistor of ILIM_LO 6.8K, then I_OS(typ)=630mA,
which means if the out current exceed 630mA or lower than 630mA,then assert the over current…
H Vincent,
The protection devices (PD) team won't have anything to protect the TLV320AIC3109 a 36 V short to Vbatt.
An overvoltage switch or zener diode could be used. A combination of both could be used as well.
From a quick glance I only see TI…
