Part Number: TPD4E001 Other Parts Discussed in Thread: TPD2E001 Tool/software: Hi team,
I have two questions.
Customer would like to use this IC on a single USB bus.
(1)
What is the recommended method to terminate unused pins? Float? tied to ground?
…
Part Number: TPD4E001 Tool/software: Hi All,
Happy new Year！
Due to the previous generation IC‘ EOL, the new one with ESD immunity downgrade from HBM 4Kv, MM 200v , CDM 750V/500V to ESD HBM 2Kv, CDM 500V.
After using the new one, we encountered…
Part Number: TPD4E001 Hi Team,
We are using TPD4E001DBVR for one our project. We needed the Simulation model(Spice/S parameter) for the same to validate our design in Ansys simulation software.
Thanks
Part Number: TPD4E001-Q1 Is there a specification for the forward voltage drop of the diode arrays inside of the TPD4E001-Q1? I am wondering if it can be used as a steering diode array on some digital signals, where the TVS portion of the TVS is connected…
Part Number: TPD4E001 Hi Texas Instrument team,
We noticed that this MPN: TPD4E001DRLR DRL Packaging is not match with footprint in CAD. You may refer to attachment.
**The IC if based on the datesheet is small than pad.
513-10974.docx
Part Number: TPD4E001 Other Parts Discussed in Thread: TPD2E001 Hi Team,
I am finding a part can P2P replace USBLC6-2. https://www.st.com/resource/en/datasheet/usblc6-2.pdf
I found that we have TPD4E001 is pin to pin with it, but we are 4 Channel instead…
Part Number: TPD4E001 Other Parts Discussed in Thread: STRIKE Hi Team,
In our C2000 evaluation kit, TPD4E001 is used as the protection circuit on DSP's ADC pin, ADC pin's absolute maximum rating is 4.6V.
I am wondering when transient event happens…
Part Number: TPD4E001-Q1
Hello,
I am confused about the maximum "I/O voltage tolerance" rating of this part. It appears that the forward voltage drop of the internal diodes is around 0.7 V (from my breadboarding tests), while the absolute maximum…
Part Number: TPD4E001-Q1 Hi team,
May I know what voltage rating 0.1uF cap should be selected as Vcc bypass cap? The application is for USB ESD protection, ESD ±6KV.
Thanks
Scarlett
Part Number: TPD4E001 Hello, I have a question for DRS package of TPD4E001. The datasheet says that thermal pad of DRS package can be left floating. Is there any performance degradation by lleaving the thermal pad floating?
Regards, Oba
