Part Number: TPD4E1B06 Tool/software: Hello,
I have found conflicting pinout in the diagram and pin table in the datasheet (rev. D) of TPD4E1B06, DCKR package variant (SC70).
Which one is correct, the image or table? See conflicting pins bellow.
Regards…
Part Number: TPD4E1B06 Other Parts Discussed in Thread: LMP91200 , Hi,
I am designing a medical-grade pH meter that needs to pass the Level 4 ESD test. The pH electrodes have very high internal resistance, so the op amp must have a very low input bias current…
Part Number: TPD4E1B06
Hey Interface team,
I have a customer evaluating the TPD4E1B06 for a new design and we found a discrepancy in the datasheet that we're hoping you can provide guidance on.
In Section 5, Pin Configurations and Functions, there…
Part Number: TPD4E1B06 The datasheet does not specify peak power and current for shorter pulses like most TVS datasheets do.
What is the rating of the part for pulses shorter than the 8/20us.
Part Number: TPD4E1B06 Hi,
We use this device in an analog frontend to protect our ADC inputs against ESD. The connection is as follows:
Where pin 1 and 2 are connected to the analog inputs. We use this device because it has a very low leakage, and connect…
Part Number: TPD4E1B06 Other Parts Discussed in Thread: ESDS314 , STRIKE , ESDS304 Hi Team,
According to the datasheet the clamping voltage can be more than 10V. We have a customer who currently uses the TPD4E1B06 as a protection diode which sits between…
Part Number: TPD4E1B06 Other Parts Discussed in Thread: TPD4E1U06 I'm choosing the chip in TPD4E1B06 or TPD4E1U06.
IEC 61000-4-4, What is the test value?
Part Number: TPD4E1B06 (1) I did not find in the datasheet the information about the clamping voltage for 16A , which corresponds to the 8kV IEC 61000-4-2 waveform.
TLP Plot only goes up to 10A.
(2) Another question is about the scale of the +8 kV…
Part Number: TPD4E1B06 Other Parts Discussed in Thread: TPD1E10B06 , TPD1E1B04 , ESD204 , ESD401 Hi,
For the below interfaces i am looking out for ESD and EFT protection. Please let me know if my selected devices are OK
1. For I2C Interface, Analog Interface…
