Part Number: TPD4S214 Tool/software: Hi Team,
Our customer is working on a USB2.0 (Full Speed) OTG circuit design and would like to implement VBUS control. I found the TPD4S214 in your product lineup and am considering it for this purpose.
Could you…
Part Number: TPD4S214 Tool/software: Hi
I am looking for the EOL status for the next 5 years/product life cycle for the following parts:
I am unable to find this on the website. Please connect me to the correct group/person from TI
TPD1E05U06DPY…
Part Number: TPD4S214 Tool/software: good morning
this may be a silly question, but I don't know how I should connect the PIN C2 which is GND, no track can come out to connect it to GND. can someone clarify me if I should leave it that way?
Thank…
Part Number: TPD4S214 In some older USB switch designs we have recommended having a discharge resistor in parallel with Vbus to slowly discharge the output cap/prevent a reverse voltage/current situation. Is this recommended for TPD4S214 and what value…
Part Number: TPD4S214 Hi,
we are looking for a USB current limit device that could tolerate 10V at VBUS, since they have met VBUS transient that break the USB current limit device. And during the surge test, the TVS on VBUS could clamp VBUS below 10V…
Part Number: TPD4S214 Hi Support team
My customer is using the TPD4S214 in a product and are seeing surged when a device is connected . they are asking about response time, so for example, if the limit is set to 500mA and the current surges to 550mA…
Part Number: TPD4S214 Hi.
We are having trouble designing the TPD4S214 and have an inquiry.
The FLT pin and the ADJ pin are floating in the circuit, and the EN pin is controlled by the controller.
The problem is that the signal of the DET Pin is…
