Part Number: TPD5S116 Other Parts Discussed in Thread: ESD224 , Tool/software: Hi, I'm using two ESD224 + one TPD5S116 in my design which connects the SOC (sys side) and HDMI Type A connector (port side). The schematic screenshot is shown below:
…
Part Number: TPD5S116 Tool/software: Hi
we have used this part for a HDMI 2.1 Port ,
as per the Data sheet chip Supports HDMI1.3, HDMI1.4, and HDMI2.0
based on the pins available it seems like i can use it for 2.1 as well
Please help to understand why…
Part Number: TPD5S116
Tool/software:
Hello Everyone,
I plan to use the HDMI companion chip TPD5S116 in my design for HDMI 2.0 & 2.1 interface.
First of all, I would like to know if TPD5S116 supports HDMI 2.1 standard.
Secondly, I would like to know…
Part Number: TPD5S116 Hi team,
My customer is checking this device, and he found VOL and VIL do not meet the I2C spec.
VOL max＝0.17×VccA (0.4V officially) VIL max＝0.082×VccA (0.3xVdd officailly)
Do we need to follow the datasheet or official…
Part Number: TPD5S116 Hi team,
Could you team me how to connect 5V_SYS, 5V_CON if I don't use the load SW_? Can I leave it open or connect to GND?
Also, could you let me know the max. and min. values of pullup voltage of SCL_SYS, SDA_SYS?
Best, Zem…
Part Number: TPD5S116 Other Parts Discussed in Thread: TPD12S016 Hello,
I am working with an engineer who likes the TPD5S116 device, but unfortunately the 0.4mm BGA is too small of a geometry for the CM for prototypes. The other HDMI companion chips like…
Part Number: TPD5S116 Hi All,
We are looking for an alternative for TPD5S116YFFR , it seems that the TPD13S523PWR could be a good choice after considering the current stock status.
May I know what is the difference between them?
A comparison table would…
Part Number: TPD5S116 Hello Expert,
My customer needs UL Certification Number and Report of TPS5S116.
They got a request from UL Certification Officer.
Could you please provide these?
Best regards,
Michael
Part Number: TPD5S116 Hi All,
About the UTI_CON in the TPD5S116, if we need to use this function.
Should we connect this pin to the Ground directly?
Will there be any problem if we connect this pin with a 10k ohm & 100nF cap in parallel to the GND?…
