Part Number: TPLD-PROGRAM Tool/software: Hi team,
Two cases have occurred in which, after updating TPLD-PROGRAM for one of my clients, the device could no longer connect to the PC. Is there any recommended solution for this issue?
Best regards,
…
Part Number: TPLD-PROGRAM Tool/software: Hi team,
TPLD-PROGRAM appears to be out of stock at the moment. Could you let us know when it is expected to be restocked?
We have a customer who is considering it and wishes to make a purchase.
Best regards…
Part Number: TPLD-PROGRAM Tool/software:
Hi Sir
I've been using the EVM to tune these past few days, and originally it was working fine. But then I got the following message.
I replaced the IC with a new one, and the results are still the same…
Part Number: TPLD1201 Other Parts Discussed in Thread: TPLD-PROGRAM , Tool/software: Hi team,
Is it possible to write data to the TPLD1201 without using the TPLD-PROGRAM or EVM?
For example, is it possible to program the TPLD1201, which is already…
FAQ: TPLD > Current FAQ
TPLD is programmed through SPI communication enabled by the programmer firmware and InterConnect Studio (ICS). Each TPLD device uses 5 pins to program the device: 4 pins for SPI communication and 1 pin (GPI) that provides a specific…
Part Number: TPLD-PROGRAM Tool/software: I want to use interconnect studio.
I have read the User'sGuide.However,I was unable to access 「interconnect_studio.itg.ti.com.」
Is there any other way to use interconnect studio?
I see, and yes that is the problem.
I followed the directions within the EVM users manuals, It shows this jumper removed in a few instances.
I suggest you modify the 2 guides to show it in place so others have a good out-of-box experience.
Thanks…
FAQ: TPLD > Current FAQ
Customers can order devices for production through InterConnect Studio (ICS). TI can program devices (at no additional cost!) before shipping with the submitted design if the order quantity is one reel or more (3000 units). …
Other Parts Discussed in Thread: TPLD1201 FAQ: TPLD > Current FAQ
TPLD is programmed through our software tool, InterConnect Studio (ICS) , in combination with a TPLD programmer and EVM. TPLD programmers and EVMs can be found on the “Hardware development…
FAQ: TPLD > Current FAQ
Once a TPLD is permanently programmed or “burned” through OTP, the design cannot be changed. If you wish to change your design after permanently programming an OTP part, a new, previously unprogrammed part must be used.
