Part Number: TPLD1201-DGS-EVM Other Parts Discussed in Thread: TPLD1201 , TPLD1202-DYY-EVM , TPLD1202 Tool/software: Hi Team,
We got error message "Device ID is not defined " when first time config TPLD1201 EVM. We didn't change and just follow the…
Part Number: TPLD1201-DGS-EVM Other Parts Discussed in Thread: TPLD1201 Tool/software: I'm designing the TPLD1201 using Interconnect Studio. In order to solder it to a separate board for use, I wrote it permanently with the power supply selection to the…
Part Number: TPLD1201-DGS-EVM Other Parts Discussed in Thread: TPLD1201 , TPLD1202 Tool/software: Hello TI team,
I am currently trying to supply externally the TPLD1201 through the EVM board with 5V, as this represents the required logic voltage for…
Part Number: TPLD1201 Other Parts Discussed in Thread: TPLD-PROGRAM , Tool/software: Hi team,
Is it possible to write data to the TPLD1201 without using the TPLD-PROGRAM or EVM?
For example, is it possible to program the TPLD1201, which is already…
Part Number: TPLD1201-RWB-EVM Other Parts Discussed in Thread: TPLD1201 Tool/software: Hi team,
My understanding is that when writing data to the TPLD1201 using the EVM, the data will be erased when the power is turned off unless it is permanently programmed…
Part Number: TPLD1201-DGS-EVM Tool/software: Hi,
EVM demo is well works, but the IO5 doesn't output H at the following circuit:
Both IO6 and IO7 are good. I can't understand why only IO5 can't go H. Seems Z.
Using demo circuit, IO5 can out H/L…
Part Number: TPLD1201-DGS-EVM Tool/software: Hi,
I think that IO9 output H pulse during startup EVM. Is it true?
Both DFFs has L intial state, so will start L outputs for IO6 and IO7.
But after clicking [CONFIGURE] at the InterConnect Studio,…
Part Number: TIDM-NFC-RW Hello,
We have tested this EVM and we are getting range around 6 CM at 18 DB gain.
We want higher range up to 12 CM, how can we increment the range with same EVM board.
Or Is there any external antenna available for this…
Hi Alisa Nozawa,
Alisa Nozawa said: Can these parts detect a 100ms width edge?
Yes, the detection of an edge is dependent on the VIH/VIL of the input and not the speed of the edge. If you are using slow input transitions such as 100ms, you configure…
Hi Malcolm,
You wrote: (red text)
Could you see what happens if you connect the input of pin IO7 to a couple of different things, such as VCC, or POR? If possible, it would also be helpful to test this normal case while connecting POR to a separate…
