Part Number: TPLD1201-RWB-EVM Other Parts Discussed in Thread: TPLD1201 Tool/software: Hi team,
My understanding is that when writing data to the TPLD1201 using the EVM, the data will be erased when the power is turned off unless it is permanently programmed…
Part Number: TPLD1201-DGS-EVM Tool/software: Hi,
EVM demo is well works, but the IO5 doesn't output H at the following circuit:
Both IO6 and IO7 are good. I can't understand why only IO5 can't go H. Seems Z.
Using demo circuit, IO5 can out H/L…
Part Number: TPLD1201-DGS-EVM Tool/software: Hi,
I think that IO9 output H pulse during startup EVM. Is it true?
Both DFFs has L intial state, so will start L outputs for IO6 and IO7.
But after clicking [CONFIGURE] at the InterConnect Studio,…
Part Number: TIDM-NFC-RW Hello,
We have tested this EVM and we are getting range around 6 CM at 18 DB gain.
We want higher range up to 12 CM, how can we increment the range with same EVM board.
Or Is there any external antenna available for this…
Hi Alisa Nozawa,
Alisa Nozawa said: Can these parts detect a 100ms width edge?
Yes, the detection of an edge is dependent on the VIH/VIL of the input and not the speed of the edge. If you are using slow input transitions such as 100ms, you configure…
Hi Malcolm,
You wrote: (red text)
Could you see what happens if you connect the input of pin IO7 to a couple of different things, such as VCC, or POR? If possible, it would also be helpful to test this normal case while connecting POR to a separate…
Part Number: TPLD1201 Hi staff,
with TPLD1201, EVM
First, I understand the CNTDLY starts with output L. Actually,
Configured TPLD1201 outputs L from startup: (IO7 = OUTPUT)
But ICS simulation output H:
Second, when RST set H level and…
Hi Owen,
Thank you for your support.
We have summarized the results of TPLD-PROGRAM writing status in our environment based on the versions of TPLD-EVM and ICS as follows:
TPLD1201-EVM + ICS 1.5.0: Writing successful
TPLD1201-EVM + ICS 1.6.0…
Hi Frantisek,
The TPLD801 and TPLD1201 cannot be programmed without the TI programmer and EVM. TI can provide pre-programmed devices or samples.
However, TPLD1202 and TPLD2001 can be fully programmed without the TI programmer. The details can be found…
Part Number: TPLD801 Other Parts Discussed in Thread: TPLD1201 , TPLD-PROGRAM , TPLD1201-DGS-EVM Tool/software:
hi sir
if TPLD801 can do the function as the table?
thanks
