Part Number: TPLD1202-DYY-EVM Tool/software: Can the TPLD1202-DYY-EVM have the external Vcc power input at 5V while the EVM is connected to the USB powered programmer? Once I temporarily program the PLD in the EVM, I need to run it at 5V so it properly…
Part Number: TPLD1201-RWS-EVM-DOC-CERT Other Parts Discussed in Thread: TPLD1201 Hello,
I’m working on a PWM generator design using the TPLD1201, and I’m seeing some unexpected behavior in simulation. I’d like to confirm whether this is expected device…
Hi Owen,
Thank you for your support.
We have summarized the results of TPLD-PROGRAM writing status in our environment based on the versions of TPLD-EVM and ICS as follows:
TPLD1201-EVM + ICS 1.5.0: Writing successful
TPLD1201-EVM + ICS 1.6.0…
Part Number: TPLD1202-DYY-EVM Tool/software: I have version 1.4.0 running. If this is not the latest version, where can I get it?
Thanks, Chris Stell
NASA Jet Propulsion Laboratory
Part Number: TPLD1202-DYY-EVM Tool/software: On the silkscreen near P2 of the EVM it reads "EXT CLK0 3V6 Max". Is this input pin really limited to 3.6V max. ? Or is it 3.6V max when powered from 3.3V. What is the maximum voltage when powered from 5V?…
Part Number: TPLD1202-DYY-EVM Tool/software: Pulse delay block are showing sensitivity to pulse duty cycle. I placed 3 delay blocks with a 47 count. The delay blocks are clocked at 10kHz. The top delay block receives a pulse with a 51% duty cycle at 10ms…
Part Number: TIDM-NFC-RW Hello,
We have tested this EVM and we are getting range around 6 CM at 18 DB gain.
We want higher range up to 12 CM, how can we increment the range with same EVM board.
Or Is there any external antenna available for this…
Hi Malcon,
The SPI header was a good suggestion. But simply switching to the SPI position didn't solve the problem.
To get to the bottom of the matter, I systematically installed and tested all subsequent versions up to ICS V1.7.3, starting with ICS…
Hi Ian:
The Power SW, I tried both ON and OFF state. It goes the same 72% then get stuck.
I had received a new TPLD1201 EVM last week and it's working on my system. Which means the bug should be somewhere on the TPLD1202 EVM.
I did a "MONKEY TEST…
