Part Number: TPS2041C Hi team,
I want to know whether the /FLT pin of TPS2041C can be floated if it is unused, or we need pull up/down this pin?
Regards,
Xiaoying
Part Number: TPS2041C Hi Team,
a customer is using TPS2041C with a 150µF load.
On their prototype they observed that the TPS2041C has a soft start time of 0.5 - 1ms but due to the large cap load 5ms would be better.
Can the soft start time be adapted…
Part Number: TPS2041C Other Parts Discussed in Thread: TPS2041 , TPS2061 , TPS2513 Hi
I would like to ask about the following application note. That is mentioned about the configuration with a power supply and load switch (such as TPS2041 and TPS2061…
Other Parts Discussed in Thread: TPS2051C , TPS2041C Hi all, Would you mind if we ask TPS2041C, TPS2051C? <Q1> The datasheet shows "Additionally, bypassing the output with a 0.01-μF to 0.1-μF ceramic capacitor improves the immunity of the device to short…
Other Parts Discussed in Thread: TPS2041C Hi,
The schematic shows a TPS2041C connection which we intended to limit current of a USB device under 0.5A. The TPS2041C has been soldered without defect.
Then the processor apply voltage to both IN and ENn…
Other Parts Discussed in Thread: TPS2041C , TPD4S214 , TPS2041B , TPS2065C-2 A USB OTG within a device is being used to charge the device but also act as a host to communicate with other USB peripherals. Would like to know if a USB host is plugged into…
Other Parts Discussed in Thread: TPS2041B , TPS2041C Hi,
For 0.5A USB current limit protection, TPS2041C and TPS2041B seems the same in many aspects. Could someone point out their difference?
For example,
Martin Pakota pointed that TPS2041B lacks…
Part Number: TUSB2036 Other Parts Discussed in Thread: TS3USB221E , , TPS2041C My goal is to design a USB-Hub for a PCB-project.
The CPU (Host) has one USB port, that can be used as host (for USB Devices) - but is simultaneous used to upload new firmware…
