Part Number: TPS22908
Tool/software:
Hi TI Experts,
We have used TPS22908YZTT Load Switch for generating 1.8V for Camera connector , after powering ON the board ,1.8V is dipping to 1.3V and the same 1.8V is given as input to the clock buffer , AND…
Part Number: TPS22908 Other Parts Discussed in Thread: TPS2113A , TPS2115A , Hi team
As shown in the figure below, there is a project that uses two load switches to select the power supply path. we want to use the original pin Vout as Vin and the original…
Part Number: TPS22908 Other Parts Discussed in Thread: TINA-TI , Encripted file cannot be used in new macro wizard of TINA-TI.
Please give access to un-encrypted spice file for TPS22908.
Does TI no longer update libraries for TINA-TI???
Other Parts Discussed in Thread: TPS22908 , TPS22922 , TPS22964C Please let me know two points below about TPS22908 and TPS22922.
- When ON signal is Hi-z, which logic does it become? Is the exterior Pull down for protection required?
- If input voltage…
Part Number: LM66100 Other Parts Discussed in Thread: TPS22908
Tool/software:
I am starting a project that requires a single "3.2V" (2V-3.65V) LiFePO4 18650 cell to be in a housing with exposed contacts, I will refer to this a the "battery pack",…
Gert,
Other than the TPS25221, the closest I found to your VIN spec is the TPS250x where VIN (min) is 1.8V. Another one is the TPS22908 , but the VIN (max) is 3.6V. These, however, are also not a single part solution. A bidirectional switch that may…
Part Number: TPS22907 Other Parts Discussed in Thread: TPS22908 Hi there:
I'd like check about the test condition for the TPS22907.
In the datasheet 6.8 Switching characteristics: VIN = 1.1V
We could find the Turn-on time is 81us (at Rload=…
