Part Number: TPS2554 Other Parts Discussed in Thread: TPS2557 , TPS2557DRBEVM-423 Could you pls help check whether TPS2554 have passed UL IEC 62368?
The same for TPS2557.
Could you pls help check whether TPS2557 have passed UL IEC 62368?
Part Number: TPS2554 Hi Team,
my customer is using TPS2554 as solution , they have a question as subject,
can TPS2554 current limit can set to 2.7A ?
customer using case is for's 3 USB port current limit use , each of port's current limit is 900mA…
Hi,
I don't know for your OTG solution, whether TPS2554 is disabled or not.
If part is disabled, the output voltage will not leak back to input.
If the part is enabled, the datasheet doesn't indicate reverse voltage blocking function.
You can…
Part Number: TPS2554 Hi,
The datasheet for TPS2554DRCT does not specifically list its VIL max and VIH min values. Closest I can find is on page 4 in the Enable Input section where it says VEN min is 0.9V and max is 1.65V with 1.1V typical. My io expander…
Part Number: TPS2554 Hi,
I presume that there is current source in the ILIMx output outputing current proportional to the OUT current to the resistor and than measuring that voltage for the overcurrent event.
If that is the case, is there any possibility…
Part Number: TPS2554 Other Parts Discussed in Thread: TPS25221 Hi,
May I know if TPS2554 will still function properly if Vin supply to IN pin drops to 4.4V, on datasheet it mentioned recommended operating condition for IN would be 4.5 - 5.5V. Since…
Part Number: TPS2554 Dear team,
Could you share UL and CB certification of TPS2554DRC with me? Thanks.
BTW,
Does this report been shared on TI.com? If yes, could you address me how to get it. thanks for your support.
benkuo@ti.com
Regards…
Part Number: TPS2554 Other Parts Discussed in Thread: TPS2553 Team,
If the applicaiton only need one current limit threshold,
Is it possible to have the ILIM_SEL pin floating?
Is it possible to have ILIM0 or ILIM1 floating or grounding?
Thank…
Other Parts Discussed in Thread: TPS2554 Hi Team,
I survey TPS2554 for my project use. but we need have special function for USB port. Could you provide concept and schematic for wake up for MCU when USB plug in? Thanks.
