Part Number: TPS25814 Hi team,
I heard the EC can acquire the polarity of USB through I2C , and then EC will notify PCH consequently.
so we don't need POL signal to deliver this message, is that true?
if yes,
where can I see this register in…
Part Number: TPS25814 Tool/software: Hi AE,
The TPS25814 Support BC 1.2, I want to know How can I set up SDP mode via the I2C or GPIO ?
Please provide any suggestion for me, Thanks!
Part Number: TPS25814 Other Parts Discussed in Thread: TPS25810 , TPS2546 Hi Team,
Customer would like to design TPS25814 and customer would like to check weather they can short D+/D- to PCH to support USB data and BC1.2.
Would you please help review…
Part Number: TPS25814 Hi Team,
I have a few doubts regarding TPS25814 IC.
1). What can I connect to the Uff port?
2). Is the UFP port a power-consuming port or a power-deliver port?
3). Can I connect a pendrive or sink device to the UFP port?…
Part Number: TPS25814 Hi Tommy,
Please reply to the continuation question below, thanks~
TPS25814: I2C to monitor status of registers and overall system settings - Power management forum - Power management - TI E2E support forums
Part Number: TPS25814 Hello, I am searching for the register set description of the TPS25814 USB supply solution. I found an question for this resource here which is already more than 1 year old but nothing has
still been published.
Part Number: TPS25814
Hi team,
datasheet doesn't cover what would happen if we disable SPM,
if we want to set maximum current limit 1.5A, can we do that by disabling SPM ?
or we must enable it to achieve.
Part Number: TPS25814 Hi team,
customer connect our EVM to their desktop mother board,
either flip or non-flip, only CC2 got recognized.
and if we unplug type-C , the interrupt pin will be pulled low,
and then if we disconnect it from…
Part Number: TPS25814
Hi team,
I'm curious since type-C current default already charge be up to 5V/3A, and do data transmit at same time just like CDP.
why TPS25814 still need BC1.2 ?
the only difference I see here is DCP and DCP_auto, am I right…
