Part Number: TPS50601A-SP Tool/software: Hello,
I am attempting to perform a monte carlo analysis using the TPS50601A-SP PSpice Transient Model Rev C on OrCAD Capture version 22.1. PSPice consistently crashes when I try to assign tolerances. Is this an…
Part Number: TPS50601A-SP Other Parts Discussed in Thread: TPS50601-SP , Tool/software: Looks like either of these parts will work for my design.
However, I'm not sure which part to use for a new design. Is it better to use the 601A going forward? …
Part Number: TPS50601A-SP Tool/software: When the device is facing a short circuit event, what will happen to the output voltage and PH node?
Could PH node scope plots be shared?
Part Number: TPS50601A-SP Tool/software: Could you please provide the IBIS Model for Post-Layout simulation Signal integrity of Sync Signal (Externally Synchronized)
Thanks in advance
Part Number: TPS50601A-SP Dear sir/ madam,
kindly provide SEU LETth for following part number since this data not available in technical data sheet.
5962R1022102VSC/ TPS50601A-SP
Part Number: TPS50601A-SP Other Parts Discussed in Thread: TPS7H1101A-SP , TPS51200 , TPS7H3301-SP Tool/software: The IPC and J-Standards require a >= 50% solder fill or <= 50% solder voids for bottom terminated components. Some of the components we use…
Part Number: TPS50601A-SP Tool/software: The datasheet suggested VRef = 0.804 as typical across the full temperature and load range. The chart "Figure 2. Voltage Reference vs Temperature" implies this is only the case at -55 degC and closer to…
Part Number: TPS50601A-SP When is the SYNC driven by the TPS50601A-SP?. Does EN have to be asserted? If EN is low will SYNC still be driven as long as VIN is within it's operating input voltage range