Part Number: TPS54526 Celestica P/N:1046875OUE
We received the part from TI under PO#3510097354 , Qty:18,000
MSL level:2 _Qty;6,000
MSL level :1 _Qty: 12,000
Please confirm , What is Date code for MSL change?
Part Number: TPS54526 What is the switching frequency range of the TPS54526? I would like to check if there is no problem with the current circuit, which raises to 785 kHz.
Part Number: TPS54526 Hi team, Do you have undisclosed errata for this device? It seems we cannot see the errata on the page of TPS54526 in the website, but please let me know if you have.
Regards, Satoshi
Part Number: TPS54526 Hi,
I am Using 4 nos of TPS54526 in my design. 5V is the input to all the regulators & outputs are 3.3V, 1.8V, 1.5V & 0.95V. Inductor value is given in the datasheet for output voltages from 1V to 5V. Can I use 1.5uH Inductor…
Part Number: TPS54526 Tool/software: WEBENCH® Design Tools Hello,
I selected the TPS54526 for my power supply design, since it met my requirements:
1. Vin is 5V to 6V
2. Vout is 3.3V
3. Iout is 5A
In table 2 of the TPS54526 datasheet, it even…
Hi,
TPS54526 don't release loop performance of WEBENCH.
I run a load transient test with TINA@1.35V out with 0.1A-5A, SR=5A/us, the results are as below. Both inductance are ok, but seems 1.5uH would have better load transient performance.
Lf=1…
Part Number: TPS54526 Hi All,
I am using TPS54526 buck converter to generate 5V from 15V input. The ENABLE pin is pulled up to Vin i.e, 15V through a 100K resistor as shown.
The issue is, on powering the board ON , theconverter is not enabled…
Part Number: TPS54526 Other Parts Discussed in Thread: TPS54531
Hi, Could you tell me about TPS54526 max duty? I got the following question from the customer.
1.When searching for products on the website,
The duty cycle of TPS54526 was written as…
Part Number: TPS54526
Hi TI,
We have designed TPS54526 based 5V DC-DC regulator in our board.I couldn't able to generate 5V output.All the other pins function as expected (EN is high, and VREG5 produces 5.5V).When probing the output, the 5V was observed…