Part Number: TPS60120 Other Parts Discussed in Thread: TLV61070A Tool/software: Hi~.
There is a difference in layout between "datasheet Figure 8-13" and "ek manual Figure 4-1."
Cin and Rfb positions are different, and the connection method of Cin…
Part Number: TPS60120 Other Parts Discussed in Thread: TLV61070A
Tool/software:
Hi~.
Ask how to connect Cin gnd and IC GND effectively for EMI.
1. Which is effective for emi, connecting directly to the IC GND pin as shown in "data sheet Figure…
Part Number: TPS60120 I am using the TPS60120 booster for a battery powered project (2x AA batteries). The cable to the batteries is approx 30cm long. Should I protect the Vin from EMI pickup in the cable with an RC filter? And what would you recommend…
Part Number: TPS60204 Other Parts Discussed in Thread: TPS61091 , TPS60120 Tha tps60204 datasheet states it can deliver (min) 100mA continuously.
I want to power a esp32C3 microcontroller (in low power mode).
However, during bluetooth transmissions…
Yeah. I have questioned with same logic. So, I will clearly send the actual process.
MSP430FR5969 Soc.
In our custom design, we are using TPS60120 with LIPO battery(4.2) supplied. So, after voltage divided with 820K and 576K, we will receive the LBI…
Part Number: TPS60122 Other Parts Discussed in Thread: TPS61022
Hi, I have a TPS60122 boosting super-cap voltages up to 5v and anywhere from 0-3A. It's not using the reference design but follows the same principles. Spec: Output: 4x 22uf/0805/X5R/10V…
Other Parts Discussed in Thread: TPS61020 , TPS60120 , TPS62160 , TPS61260 , TPS61070 I am designing for a low-current application. Peak current will be ~ 30 mA, in very short bursts, and average current will be < 200 µA during operation. The power will…
Other Parts Discussed in Thread: TPS60120 , TPS61107 , TPS60140 I am trying to convert my current application with TPS60120 (200mA max) to TPS61107 to get about 280mA from two cell Ni-MH batteries (~2.4V)
TPS 61107 starts just fine at 3.3V and 140mA…
Hello,
The UCC3806 is a dual output controller though it can be used in a flyback where only one of the outputs are used to drive the switch it might be better to choose a single output controller. Look at page 46 of the attached under General Purpose…
