Part Number: TPS60250 Hi E2E,
When we used TPS60250 for ESD test-- air discharge (15kV).
The IC will trigger protection and shut down during the test.
At this time, we keep the power-on state, and restore the test environment to normal conditions…
Other Parts Discussed in Thread: DRV201 , TPS60250 Hi
I have got the evl module for tsp60250.
I install the software from the disk and connected it to power source.
nothing is working. I saw in the print screen from page 5 of the evl datasheet that…
Hi,
I am not saying that TPS60250 would not be a good fit to your application. I was just offering you other choices in case you want smaller pin number. Also I am more acquainted with LP5521 than TPS60250. So feel free to choose what ever suits the…
Here are some examples of a software I2C for the MSP430 to start with:
MSP430 Interface to TPS60250 via I2C Master Software
Software I2C Slave Using the MSP430
Interfacing the MSP430 and TMP100 I2C Temperature Sensor
I would say the…
I don't recall there ever having been an app note to implement software I2C on 64x. I've seen such app notes for other processors. For example:
MSP430 Interface to TPS60250 via I2C Master Software
Perhaps you could port that example to run on the…
Hello,
The UCC3806 is a dual output controller though it can be used in a flyback where only one of the outputs are used to drive the switch it might be better to choose a single output controller. Look at page 46 of the attached under General Purpose…
Siyu,
I think the toggle flip-flop in the block diagram on page one of the spec should have let you know that the max you will get with this device is 50% duty.
Go to page 43 and 44 of the attached and select a more suitable part.
Peter,
i am enclosing the Power Management Guide for 2011. The section you will be interested in starts on page 43 and actual devices listed on page 46, With the minimum information you have given me I would expect that you will want something like…
