Part Number: TPS629210-Q1 Dear TI experts,
My customer asked buck converter under the condition below.
Vin=5V
Vout=0.5V
Iout=1A
AEC-Q100 is required.
Actually I suggested TPS62921-Q1 based on WEBENCH simulation.
But it simulated as 0.4V…
Part Number: TPS629210-Q1 Hi, I saw a similar forum regarding using in between values for the Rset value to get a certain voltage but had no clear answer. My question is are we able to use resistors inbetween the Rset to Voltage chart and get different…
Part Number: TPS629210-Q1 Tool/software: I would like to have some help with the Failure Mode Distribution for the following part number TPS629210-Q1 , this is usually included in the Functional Safety FIT Rate, FMD and Pin FMA report , but I cannot locate…
Part Number: TPS629210-Q1 Other Parts Discussed in Thread: LMR36506-Q1 Tool/software: Hi all,
I'd like to confirm the internal structure of TPS629210QDRLRQ1 about SOT-5X3 (DRL) | 8
1) Is this the Flip-chip structure? Does this device have the same…
Part Number: TPS629210-Q1 Tool/software: Hello
As regards the out circuit protection test, the Vout didn't decrease to 0V and the I-load increase to 1.58A when I press the electronic load short button.
And the Vout didn't decrease to 0V either…
Part Number: TPS629210-Q1 Other Parts Discussed in Thread: TPS629210EVM Tool/software: I am looking for some help with some power supply fluctuations I am having with a XTPS629210QDRLRQ1. I have designed the board with the 2.2uH inductor and 22uF capacitor…
Part Number: TPS629210-Q1 Other Parts Discussed in Thread: TPS62903 Tool/software: Hi support team, This is a question about Inverting Buck - Boost.
Isn't the minimum input voltage for IBB just "3V" and not "3V + VOUT"?
www.ti.com/.../slvafc5.pdf…
Part Number: TPS629210-Q1 Hello
The mode will be Forced PWM if I tied the MODE/S-CONF to high, but in the meantime, the DYNAMIC MODE CHANGE is Active. I'm confused as to whether my configuration is Forced PWM or switching frequency changeable?
Part Number: TPS629210-Q1 Other Parts Discussed in Thread: TPS629210 Tool/software: Hello
We are doing the line transient test now. The output of TPS629210 is unstable while the Vin blow 8.6V, with fully loaded I A (Test condition: Vout =3.3V, I-load…
Part Number: TPS629210-Q1 Hi support team, This is a question regarding equation (7) of SLVAFC5.
https://www.ti.com/lit/an/slvafc5/slvafc5.pdf
The "Low-side FET current limit" of 1.3A is applied to IL(max). Isn't the "High-side FET current limit…
