Part Number: TPSM82912 hi sir
I would like to design the Altra FPGA/ A5EC013BM16AE6S in our prouct
need the PMIC ,Did you have any suggestion?
power rail as below,thanks
Rail
voltage(mv)
Static Current(A)
Dynamic current…
Part Number: TPSM82912 Tool/software: This screenshot is from TPSM82912RDUR power IC.
Which one is more correct
1) Placing feedback resistors after filter network
2) Placing feedback resistors before feedback network
I think in the below case…
Part Number: TPSM82912 Dear Team,
do you have a suggestion on input EMC/EMI filter for the TPSM82912 in
1) Normal configuration Vin =12V , Vout = 5V, Iout= 1A?
2) IBB configuration Vin = 5V, Vout = -5V, Iout =1A?
Best Regards
d.
Part Number: TPSM82912 Tool/software: Dear Sir
I have to use TPSM82912/3 in my design and also i need module for nrgative voltage like this part for +2.5V 500mA load
Can you suggest the any part no that can be used for negative voltage -2.5V 500mA…
Part Number: TPSM82912 Dear Team,
As the TPSM82912is a low-ripple buck module with integrated ferrite bead fillter we would like to use it in IBB configuration to generate negative voltage is it possible?
Option 1) 12V to -5V
or
Option 2) 5V to…
Part Number: TPSM82912 Tool/software: Hi,
I apologize for the late reply.
The thread was closed due to my late reply. I will post a new one.
https://e2e.ti.com/support/site-support-group/site-support/f/site-support-forum/1510439/tpsm82912-output…
Part Number: TPSM82912
Tool/software:
Hi,
I connected a 100Ω or 68Ω load resistor between TP4 and AGND and checked the output voltage. However, the output voltage was 0V.
Could you please check whether there are any problems with the circuit diagram…
Part Number: TPSM82912 Tool/software: Hello, My customer would like to use TPSM82912 at Vin=12V, Vout=5V Iout(max)=1A. And the DESIGN GOAL is “Typical”. Q1: In the Table 8-2 of the datasheet, the OUTPUT CAPACITOERs are blank for their conditions. What…
Part Number: ADS124S08 Other Parts Discussed in Thread: TPSM82912 , LM27762 , Tool/software: Hello,
I am currently looking into power supplys for the ADS124S08. I am new to hardware design and I feel kind of lost with all the things I have to consider…
