Part Number: TRS3232E-Q1 Tool/software: Hi team,
What is the internal fucntion connected to C1+/- pins and C2+/- pns? Are these pins connected to internal charge pump?
Also, what is the allowable maximum working voltage of C1, C2, C3 and C4 on the…
Part Number: TRS3232E-Q1 Tool/software: Hello, in the Datasheet for TRS3232-Q1, the Drivers have a maximum rating of +-13.2V. We need to protect against continuous overvoltages of up to 16V.
Could we simply use a series resistor and some clamping diodes…
Part Number: TRS3232E Other Parts Discussed in Thread: MAX3232E , Tool/software: Hi
We have an Integrated circuit failure ,where the IC failure is detected after dipping in Nano coating solutions(Promosolv UT 10) , the PCBA which has 28 Integrated circuits…
Part Number: TRS3232E Hi Team,
We have some question about TRS3232ECPWR.
We find DB9 CNT have two kinds of pin define, which one is correctly?
In our EVM , DB9 pin (female) define below
https://www.ti.com/lit/ug/sllu320/sllu320.pdf?ts…
Part Number: MAX3232E Tool/software: Now I am looking RS232 for New project but I not found difference between MAX3232EIDR and TRS3232EIDR.
In addition to pricing on TI web.
Part Number: TRS3232E-Q1 Tool/software: Dear team,
My customer would like to use TRS3232E-Q1 for their application.
At datasheet, we can see " If only one driver is needed, the unused driver input should be connected to VCC or ground."
But how about…
Part Number: TRS3232E-Q1 Tool/software: Hello all,
I have a following scheme:
I have 130ohm resistor at VCC input to protect supply in case of VCC short to GND.
According to a datasheet the current consumption is:
However I measure about…
Part Number: TRS3232E-Q1 Tool/software: Hi all,
Is it a problem that voltage is applied to the input and output when the power supply voltage is not applied? It is not written up to Vcc, so I understand that it is fine.
Also, if there is no problem…
Part Number: TRS3232E-Q1 Other Parts Discussed in Thread: SN65HVD1780-Q1 Tool/software: As described in the specification, the maximum withstand voltage of the Dout pin is ±13.2V, but the short circuit to power supply test of the car requires a short…
Part Number: TRS3232E-Q1 Tool/software: Hi Expert,
Greetings!!!
We had used one of transceiver part PN# TRS3232EQPWRQ1 in the design. For schematic RS232 part signal connect followed application circuit which given in below.
Link: www.ti.com…
