Part Number: TRS3232E Dear team,
Please review customer schematic as below, customer connect RS232A_CTS with RS232B_RTS, they found when RSA_CTS high, but RSA_RTS is low, and RSB_RTS is low.
Customer test CTS independently, they found when RSA_CTS…
Part Number: TRS3232E-Q1 Other Parts Discussed in Thread: TRS3232 Hello team,
For TRS3232E-Q1, can you confirm if the following use case is okay?
The datasheet specifies Receiver input voltage up to 25V, so it’s expected that the different supply…
Part Number: TRS3232E Dear team
The test result of FTDI RS232 RTS & CTS are FAIL. The reasons are as follows 1. As shown in Figure 1, FTDI RS232 RTS hi/lo setting, I can measure the signal change at the measurement point of side A (IMX8). But the signal…
Part Number: TRS3232E Hi team,
Customer used Sipex SP3232E, I promoted TRS3232E to replace.
When replacing SP3232E with TRS3232E in customer board by welding, it can't commnicate successfully.
Do you know why?
Thanks!
Part Number: TRS3232E-Q1 Hi Experts,
Can you please provide values for below parameters for the part TRS3232EQPWRQ1
Thermal Resistance Junction -to- Case
Thermal Resistance Junction-to-board
Thank you in advance. Kind regards, Gerald
Part Number: TRS3232E Other Parts Discussed in Thread: TRS3232 , MAX3232 , MAX3232E , TRSF3232E , TRSF3232 Hi Experts,
My customer is sleceting the 232 interface, they have selected the TPT3232E-SO3R.
I want to recommand the TRS3232EIDR or TRS3232IDR…
Part Number: TRS3232E Hi E2E,
I was reading the datasheet and I saw Figure 4. showed input was 3V.
tPTHL than was measured from 3V to -3V.
If the input is 3.3V or 5V, should the tPTHL be measured from 3V to -3V also?
If I am wrong, please help…
Part Number: TRS3232E Hi Support The TRS3232ECPWR is origin design but they need high-temperature application so change to TRS3232EIPWR but can't use. Do you know why? Does the spec look like not any different, Is the driver? The customer wants to use…
