Part Number: TS3A24157 Other Parts Discussed in Thread: TS3A24159 Tool/software: Hello,
I would like to know if the TS3A24159 IC can be used for switching communication between CAN and UART while maintaining the CAN standard and ensuring ESD protection…
Part Number: TS3A24157 Tool/software: Hi Support teams,
We are using three TS3A24157 switches in series in the UART path. Will this affect the UART signal quality? Thanks.
Part Number: TS3A24157 Other Parts Discussed in Thread: TMUX131 , TS5A3359 Tool/software: Hello forum, I am testing a prototype product where I use the TS3A24157 to multiplex two signals. Testing my device (that doesn't work), I narrowed the problem down…
Part Number: TS3A24157 Tool/software: Hi TI, This is Steve
I need to control a system which include SBC (single board computer) and battery
1.
The battery have a spst switch, after measurement
This spst, one contact is pull up 4V with 300K ohm…
Part Number: TS3A24157 Other Parts Discussed in Thread: TS5A623157 Hi,
in the enclose threat
https://e2e.ti.com/support/switches-multiplexers-group/switches-multiplexers/f/switches-multiplexers-forum/390098/i2c-2-1-multiplexer-application-for-ts3a24157…
Part Number: TS3A24157 Hi,
I found when P3V3_BMC_AUX = 3.3V, IN1/IN2 pull low, COM2 still have leakage ~2.0V to MCU.
But if I pull COM2 to GND, this leakage is disappear.
Do you know why may cause this leakage form COM2 to NO2?
Thanks!
Je…
Part Number: TCA9803 Other Parts Discussed in Thread: INA226 , , TMP468 , TS3A24157 Hi,
In our current design, we are using the below components. Kindly , share the electrical characteristics, Voh (min) , Vih (min) , Vol (max) , Vil (max) for completing…
Part Number: TS3A24157 Other Parts Discussed in Thread: TS5A23157 Hello E2E Team,
I am looking for a chip which allows me to use same UART port (RX & TX) for connecting two different peripherals.
A low cost & small size chip is preferable. My voltage…
Shlomi,
I searched the switches and multiplexers e2e forum for “TS3A24157” and the first post the comes up is TS3A24157: Connection between COM and NO/NC when VCC=0v that tells you TI does not guarantee the state of this switch without a valid supply…
