Part Number: TS3A4741 Hi,
There is an analog switch in my i2c design, but I notice a long time test will appear i2c access fail, we are debugging now.
can you help to check if TS3A4741 can be used in i2c bus?
Here is the BD.
Thanks,
C…
Part Number: TS3A4741 Other Parts Discussed in Thread: TMUX1575
Hi Team,
may we know the VIL and VIH voltage value when V+ 2.5v? becasue the specification not marked.
there are only 1.8v and 3v specification.
In addition, could help if there…
Part Number: TS3A4741 Other Parts Discussed in Thread: TMUX1208 , TS3A27518 , TS5A26542 Hi Team,
I would like to know if TS3A4741 the supply current increases from less than 1µA to >50µA if VDD 3.3V is used together with 1.8V Logic similar to TMUX112x…
Part Number: TS3A4741 Hi team,
looking for SPST switch similar to TS3A4741 which could hold its state after power off. Do we have something like that?
Mechanical solution is not acceptable in this case.
Thanks!
Part Number: TS3A4741 Hello,
how can I confirm RoHS2 (2011/65/EU) compliance?
I was able to find that anything we use from TI is RoHS compliant, but I need for sure to know it is RoHS2 compliant (or even better in compliance with amended version…
Ranita,
As you can see in the datasheet in the detailed design procedure and the power supply recommendations section, our signal switches can operate without any external components. However it is always a good practice to place bypass capacitors as…
Other Parts Discussed in Thread: TS3A4741 I am considering using the TS3A4741 analog switch to isolated a rail from being back-powered by another supply through an I/O. What I want to do is make VCC the 3.3V rail that could be shut down. I am hoping that…
Part Number: DS125DF410 Other Parts Discussed in Thread: TS3A4741 Tool/software: In our design we are using 4 number of DS125DF410 IC to cater for 16 10G transceivers of Agilex 7 FPGA.
We are interested to provide both master and slave configuration…
Other Parts Discussed in Thread: TS3A4741 Hello,
I'm trying to figure out how to switch rs-485 data lines (+ and -). I want to do this because my application does not support the normal bus topology and it must be like a star topology. I was thinking…
