Part Number: ETHERNET-SW Other Parts Discussed in Thread: TS3L301 Tool/software: Dear
I am Jeyong Jeong.
I have a question about TS3L301.
1. System diagram.
2. Symptom
Normal: When the Earth (PE) is connected to the PC, the network is normal…
Part Number: TS3L301 Tool/software: Hello,
i want to build a Gigabit Ethernet Multiplexer with two inputs switchable into one output, in the opposite direction (one input into two outputs) i have done it before with the TS3L301.
Is there a Gigabit…
Part Number: TS3L301 Tool/software: Hello, What is the absolute maximum junction temperature Tjmax for TS3L301? Datasheet says:
Max operating free-air temperature: TA = 85C
Package thermal impedance: θJA = 70C/W
Abs Max ON-state switch current…
Part Number: TS3L301 Hi team,
Customer is looking for any data about cable discharge event for this device.
Could you confirm this?
Please see the link as below for what the cable discharge event is.
https://www.ti.com/lit/an/snla087a/snla087a…
Part Number: TS3L301 Hi Team, Magnetics are used for protection against faults, transients and common mode signals(caused by EMI, noise picked up by the cable, impedance mismatches) between two transceiver IC's. Magnetics also provide galvanic isolation…
Part Number: TS3L301 Other Parts Discussed in Thread: TS3L501E , Hi,
I have to realize a Mux/Demux showed in the attached picture for automatic testisting.
The two masters don't have to work simultaneously.
First of all I would like to know if I…
Harish, The TS3L301 can handle voltages from 0 to 5.5V so passing a 3.3V signal should be fine. These are passive FET switches so what the switch can handle is dependent on the voltage and frequency. So as long as the I/O signal is between 0-5.5V and…
