Part Number: TS3L501E Hi team,
when using TS3L501E to switch ON/OFF the input net cable. do we need a signal transformer before the TS3L501E or we can connect the input to the device?
Hello Elena,
After lookin at your latest response. Here is some extra info that might help you if I am understanding your question correct.
Elena Faventi said: I'd like to find out if there is an existing solution to the problem of switching between…
Part Number: TS3L501E
Hello team,
I'm Raito Daikuhara TSR in TIJ.
My customer is considering using TS3L501ERUAR. My customer found the duplicate content in the reel specification table on page 21 of the datasheet. Is this a typo or is there a special…
Part Number: TS3L501E Hi team,
There are two questions about TS3L501ERUAR:
1. How to connect LEDA0/1/2, LEDB0/1/2, LEDC0/1/2 when they are unused? Pull-up, pull-down or disconnected? What resistance value should be selected for pull-up or pull-down resistor…
Part Number: TS3L501E Other Parts Discussed in Thread: TS5A22362
Hi,
One of our design circuit uses TS3L501E to switch b/w two Ethernet networks. I have the following questions:
The post here says: " Yes, driving the ethernet lines while the device…
Part Number: TS3L501E Hi, I want to use the TS3L501E to switch between two ethernet cables. Is it possible to use the TS3L501E without magnetics on either side of the mux? In other words, just insert the mux in line of the CAT5E cables? All the data-sheet…
Part Number: TS3L501E Other Parts Discussed in Thread: TS5L100 This is related to my other post below:
https://e2e.ti.com/support/switches-multiplexers-group/switches-multiplexers/f/switches-multiplexers-forum/1200168/ts3a27518e-ts3a27518ertwr-for-switching…
Part Number: TS3L501E Hi Team,
Good day ,
Please help provide an IBIS/AMI or Spice simulation model of below parts :
TS3L501ERUAR
TS3V712ERTGR
Best Regards
James Man
Part Number: TS3L501E Other Parts Discussed in Thread: TMUX646 , TS3L500 Hello!
We need a 2.5G Ethernet port for switching. The schematic diagram is as follows.
The test found that after two change-over switches, the 2.5G signal could not be switched to…
Part Number: TS3L501E Hello,
My customer is considering using the TS3L501E in the following application:
Is it okay to use TS3L501E for the above use case?
In particular, can the TS3L501E be damaged by ESD coming from the RJ45 connector? Do you have…