Part Number: TS3USB31 Hi TS3USB31 Datasheet says that Tie OE Pin High for disconnecting the bus.
This TS3USB31 is connected to STM32F767ZI. Both STM32 and TS3USB31 will get powered on simultaneously. I want the bus to be disconnected by default, so…
Part Number: TS3USB31 Other Parts Discussed in Thread: TMUX136 I need to know if exist a Texas IC that like the component TS3USB31(high-speed USB 2.0 bus isolator with single enable) is able to isolate an USB3.0 BUS with single enable.
Part Number: TS3USB31 Hi.
The TS3USB31 datasheets that the NC pin may be connected to ground or left floated on page 3, but then states that the NC pin should be left floating on page 13.
Could Ti confirm whether NC may be connected to GND?
…
Part Number: TS3USB31E Hi team,
My customer looks for simple SPST switch for 1000BASE-T and USB2.0. However, ethernet switch family of TS3L50x only has SPDT switch.
Is there any concern to use TS3USB31E for both 1000BASE-T and USB2.0?
TS3USB31E…
Part Number: TS3USB31E
Hi expert,
Referring to USB specfication Rev2.0 "7.1.1 USB Driver Characteristics", The USB port can withstand voltages from -1.0 to 4.6V.
In the other hand, Referring to TS3USB31E datasheet "6.1 Absolute Maximum Ratings"…
Part Number: TS3USB31 Team,
Our customer is asking for the current required by TS3USB31 in the following conditions.
VCC = 3.8V
OE\ = 1, disabled
D+/D- = low
I don't see this or a similar spec in the datasheet. Can you help please?
Thanks…
Part Number: TS3USB31 Other Parts Discussed in Thread: TS5USBC402 Hello Team
When TS3USB31 vdd is 5V, Can apply 5V to D+/D- line? what will happen when applied?
If not, could you suggest a solution to replace AZAW2110S?
Part Number: CC2531 Other Parts Discussed in Thread: TS3USB31 Hi, TI support team.
I already asked this issue with previous post, but I would like to ask you again.
We are concerning with USB signal voltage would be added to CC2531 DP/DM pin in spite…
