Part Number: TSER953 Hi Team,
I am using TSER953 part for CSI2 single lane mode.
Can you please tell me the current consumption for using only single lane.
Part Number: TSER953 Other Parts Discussed in Thread: TDES954 Hi,
Please advise the below support need:
1. We use the TSER953 & TDES954 for camera signal Serializer and Deserializer, we wants to know there are any test equipment promote to measure…
Part Number: TSER953 Hi,
I'm thinking of using the TSER953 to transmit MIPI CSI-2 over long distances. Is it possible for the TSER953 to convert low-rate signals such as MIPI CSI-2 640 x 480 30fps to V3Link and transmit them?
Similar products from…
Part Number: TSER953 Other Parts Discussed in Thread: TDES954 I have CSI-2 with 600Mbps/lane and 4 lanes on TSER953 input port. I configured the TSER953 trough des TDES954. TSER953 is on RX0. i2c addr tdes: 0x68, i2c-addr tser: 0x30. i2c transfers:
…
Part Number: TSER953 Hi Support Team,
I am using MIPI CSI-2 1lane with TSER953. I want to switch the CSI-2 port for AW design reasons. Is it necessary to set registers?
I am thinking that I should connect only the port I want to use and leave the…
Part Number: TSER953 Other Parts Discussed in Thread: TDES954 Hello Everyone,
I am designing a board that has both a Camera Module (MIPI) and an IMU (I2C). In a previous post it was confirmed that both can be connected to a TSER953 which is then connected…
Part Number: TSER953 Other Parts Discussed in Thread: TDES954 Hi Team,
customer is working with TSER953 & TDES954 on a medical product. They have a set-up with two EVMs.
The two evaluation boards are connected with a Fakra cable. However, the Fakra…
Part Number: TSER953 Hi Support Team
I would like to confirm FC DATA RATE and CSI BANDWIDTH.
From Table 7-7, Clocking Modes, when the internal clock is 24.2 MHz in CSI-2 asynchronous mode, the following is correct. FC DATA RATE :24.2×80=1.936Gbps…
