Part Number: TUSB1044 Tool/software: Hello,
I have a Type-C application where we support USB 3.0 Gen2 x 1 as well as 4-Lane DP Alt-mode input and output. I would like to use the TUSB1044 in I2C mode so that we have greater control over the equalization…
Part Number: TUSB1044 Other Parts Discussed in Thread: TUSB1104 , TUSB1064 , TUSB1146 , Tool/software: HI
We are working on the laptop design based in the intel alder lake laptop. We are using TUSB1044RNQR redriver for the type c functionality (USB+DP ALT…
Part Number: TUSB1044 Tool/software: Hi TI team,
Currently we have a board with the below configuration. Can you please help with the register settings or the HW strapping options that match the below configuration.
Part Number: TUSB1044RNQEVM Other Parts Discussed in Thread: TUSB1044 , TUSB1021Q1-EVM Tool/software: hi
we are working on the laptop project based on intel alder lake processor in which we are planning to use the two type c both supports USB+DP ALT Mode…
Part Number: TUSB1044 Tool/software: Hi Team,
May I know where to download TUSB1044 profile for Sigcon Architecture GUI?
Based on the APN, https://www.ti.com/lit/an/slla655/slla655.pdf , it mentioned to download TUSB1044 Profile Updater for usage, but…
Part Number: TUSB1044
Tool/software:
Hi, Support Team
our client use NXP PTN38003A , and we want change to TI solution.
the client spec is support Type-c headphone, so AUX switch is from Type-C Audio, about TUSB1044 could detection AUX switch but we do…
Part Number: TUSB1044 Tool/software: Hello,
I see the limitation in the datasheet that the length between the Type-C connector and redriver should be no more than 1.5 inches. Is that assuming a standard IL budget for a cable of 6dB (at SuperSpeed Gen2…
Part Number: TUSB1044 Tool/software:
The customer pulls the I2C signal from the CPU to the redriver IC and issues instructions to the IC through I2C.
But when the device is plugged in after setting, the values in the Registers will be cleared and…
Part Number: TUSB1044 Other Parts Discussed in Thread: TCA9509 Tool/software: Hi Team,
Could you please help confirm if there are any potential risk for I2C signal in snapped waveform? From my understanding it shall be okay and electrical test are passed…
Part Number: TUSB1044 Tool/software: What is the interface voltage of this chip in volts? Can we use 1.8V? Or if the application is 3.3V or 5V, please help explain. Thank you!
