Part Number: TUSB213 Hi Team,
On power up, I understood from the datasheet that Vcc must rise to 4.4V and RSTN must be enabled 100us later.
However, in Reference Schematic, GND is connected via 100 nF. Is not it impossible to keep the sequence?…
Hi Shawn,
1. This is correct TUSB213 or TUSB217 would work in this application. I recommend TUSB217 as it is our lastest USB 2 redriver.
2. You figure is correct, the re-driver should be placed as close to the connector as possible. Please review…
Part Number: TUSB217-Q1 Other Parts Discussed in Thread: TUSB213 , TUSB217 Hello team,
I have a question about TUSB217-Q1 RX sensitivity function. I do not know the difference from AC boost of the similar function in TUSB213.
What is the difference…
Part Number: TUSB213 Other Parts Discussed in Thread: TUSB211 , TUSB215 , TUSB212 , Hi Sir
I saw TUSB21x have new device about TUSB211~TUSB215
May I know what's different ??
We have a requirement for daisy chain application
Thanks
Part Number: TUSB213-Q1 Other Parts Discussed in Thread: TPS254900-Q1 Hi TI team
I have to design an active USB POD that will be connected to an In-Vehicle-Infotainment head unit. You will find attached my first hardware block diagram. The interface…
The TUSB213 is a bidirectional part meaning that it does not matter which side, Host or Device, the D1 or D2 pins are connected to. The signal flows through the chip rather than being connected by the trace under the device like the TUSB214. The TUSB213…
Hello Otto,
The length is not the only variable that affects the signal, in this case appears that the cable 2 has higher quality and therefore lower loss profile than cable 1.
Regards,
Diego.
Part Number: TUSB211A Other Parts Discussed in Thread: TUSB213 , TUSB212 , TUSB216 Tool/software: Hi TI team,
Is there an IBIS model available for the TUSB211A? Or any other simulation models like HSPICE or etc?
Regards,
Ken.
