Part Number: TUSB2E11 Tool/software: Hi,
We are using TUSB2E112YCGR EUSB repeater in our design. As our soc supports EUSB of 1.2V we took this part.
But the supporting voltage of SCL, SDA, gpio's mentioned as 1.8V. will this part support I/Os with 1.2V…
Part Number: TUSB2E11 Tool/software: Hi team,
I have a customer with the below question. Let me know what you think and thanks in advance!
"Had a quick question regarding the TUSB2E11 eUSB repeater. The datasheet mentions it has CTA-936 USB Carkit…
Part Number: TUSB2E11 Tool/software: Hi team, Could you please help to check two questions as follow：
1、 From the databook of TUSB2E11, I see that this device should only have supplies power-on time requirements, but no power-on-reset sequence requirements…
Part Number: TUSB2E11EVM Tool/software: Hi,
How do we measure this electrical parameter & equalization specs with the EVM and what are equipment needed ?
Is there a training material or tutorial on testing this part ? Thanks.
Part Number: TUSB2E11 Tool/software: I want to use the TUSB2E111YCGR as a very basic "eUSB2<=>USB2" level converter (no I2C or GPIO needed, no charger) without any configuration over I2C bus.
Table 5-4 on the datasheet doesn't provide such…
Part Number: TUSB2E11 Tool/software: Hi team,
Could you help to check two questions from my customer?
1. If SOC can support loop back in software, does our TUSB2E11 support external loopback? The block diagram is shown below.
2. Customer needs a method…
Part Number: TUSB2E11 Hi team,
My customer test the device and the hardware set up is below:
PC <---> TUSB2E11 USB port ------ TUSB2E11 eUSB port <---> device
PC can not enumerate the device correctly with the setup of below "A" mode. While…
Part Number: TUSB2E11 Other Parts Discussed in Thread: TPS25221 , TPS2546 Hi Nicholaus,
if customer want to use TUSB2E11 support CDP(1.5A) or SCP(0.9A),
how should we design the external circuit to control the current limit of the 5V USB according to…
Part Number: TUSB2E11 Other Parts Discussed in Thread: TPS2561 , Tool/software: Any eUSB2 repeater IC which have features of both TUSB2E11 and TPS2561 ?
Part Number: TUSB2E11 Hi Team,
Could you please advise if we could place VIA for VDD33 and VDD18 just under the PIN? Or it is recommended to place a short trace to avoid the ball overlapping with VIA?
From DS, seems like VIA just be placed under the PIN…
