Part Number: TUSB320LAI Other Parts Discussed in Thread: TUSB320 Tool/software: Hi Experts,
We have used TUSB320LAI in our design to support DRP mode. The intention of using it is to switch between UFP & DFP based on the external attached device mode…
Part Number: TUSB320LAI Other Parts Discussed in Thread: TUSB320 Tool/software: Hi
We used TUSB320LAIRWBR in our design. Since the port is set up as DRP, it is left disconnected. Pins INT_N/OUT3, SCL/OUT2, and SDA/OUT1 are terminated on test points…
Part Number: TUSB320LAI Other Parts Discussed in Thread: TUSB320 Tool/software: Dear Texas Instruments Support,
I am working on a project where I need to configure the TUSB320LAI (USB Type-C Configuration Channel Logic and Port Control) using a PIC16F1508…
Part Number: TUSB320LAI
Hi,
Our product uses the TUSB320LAI CC channel controller for USB-C port control. As per the EU Common Charger Directive , we are required to comply with EN IEC 62680-1-3 .
Based on other discussions in this forum, the…
Part Number: TUSB320LAI Tool/software: Hi,
Looking to use a TUSB320LAIRWBR in a design (configured as a UFP) to connect to a USB-C connector and supply power to bring up the PCB when connected. Power needed is approximately 10W. Is this IC the best…
Part Number: TUSB320LAI Other Parts Discussed in Thread: BQ24259 Tool/software: Hi :
I want to use TUSB320LAI with BQ24259 to replace my old USB OTG circuit.
I have asked a question about this , but TI suggest that TUSB320LAI and BQ24259 should be…
Part Number: TUSB320LAI Other Parts Discussed in Thread: TPD4E05U06 , TUSB320 Tool/software: Hi team,
I have a question regarding the TUSB320LAI.
The ESD rating is noted in the datasheet, but I would like to confirm whether this applies to all pins…
Part Number: TUSB320LAI Other Parts Discussed in Thread: TUSB320 , Tool/software: Hi TI team,
TUSB320 can work with 3V3 VDD input.
Now we want to support 5V/3A output. Regarding the datasheet, we increased the VDD to 5V. But now it doesn't work…
Part Number: TUSB320LAI Tool/software: Hi team,
In the following TUSB320LAI datasheet note that, if I2C is pull up to 3.3V, VDD need to be 3.0V and above.
Customer now I2C pull up voltage is1.8V, since our TUSB320LAI VDD power supply range is 2.7V…
Part Number: TUSB320LAI Other Parts Discussed in Thread: TUSB320 , Tool/software: Hi,
I noticed that CC1 pin connects the current source in the datasheet as the picture shown. I know that there are two CC models, pull-up/pull-down CC model and current…
