Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: TUSB322I Other Parts Discussed in Thread: TUSB322 Dear Team,
I found communication from 2 years ago about the availability of a Linux driver for the TUSB332I. At that time there was no Linux driver. Has this changed meanwhile by any chance…
Hattori-san
When VDD is off, TUSB322I non-failsafe pins (VBUS_DET, ADDR, PORT, ID, OUT[3:1] pins) could back-drive the device if not handled properly. When necessary to pull these pins up, it is recommended to pullup PORT, ADDR, INT_N/OUT3, and ID to…
Part Number: TUSB322I Hi,
On the TUSB322I datasheet, 6.5 Electrical Characteristics, we can find "Control Pins: EN_N, ADDR, INT/OUT3, DIR, ID" section. Although this table is described on specific pins, we can not find name of DIR pin. Could…
Part Number: TUSB322I Hi
I am trying to choose interface IC for USB Type-C Configuration Channel Logic and Port Control.
I saw the relevant components: TUSB320I and TUSB322I (with I2C interface).
The main difference between TUSB320I and TUSB322I is VCONN…
Part Number: TUSB322I Other Parts Discussed in Thread: TUSB422 , TUSB322 Hi
Could TUSB322/TUSB422 replace FUSB301BMPX? Or do we have any better choice? Thanks.
BR
Part Number: TUSB322I Hi,
Looking for TUSB322I reference schematic. The EVM user guide does not have it. Kindly share the same
Thanks and Regards,
Muthu
Part Number: TUSB322I Hi Expert,
Customer used TUSB322I and have some questions would like to clarify.
1. INT_N(pin6) is 1.8V, R925 is open, not mounted. When there is a device attached, INT_N would pull low(0V), but when device is detached, why INT_N…
Part Number: TUSB322I Hi Team:
I have one question, if it is a must to add a 100uF cap at VDD? or if it is also possible to use 10uF MLCC? because the E cap is not considered currently for customers. thanks!