Part Number: TUSB522P Tool/software: In Section 8.4.1 Layout Guidelines (P.15) of the latest datasheet (rev.E), it is stated at the end: “Each pair must be separated by at least 5 times the signal trace width.”
Does this refer to separating the TX pair…
Part Number: TUSB522P Tool/software: Hi,
We are Using USB3.0 Re driver part number ( TUSB522PIRGER) and need to communicate a 2-meter cable length with the board to board.
Please advise me on what setting logic needs to fix EQ1, EQ2, DE1, DE2…
Part Number: TUSB522P Other Parts Discussed in Thread: TUSB564 Tool/software: Hi Sir,
My customer would like to use the TUSB522P for for 3m length FFC cable, could you please review the below figure and advise some comments? Thanks!
FFC cable insertion…
Part Number: TUSB522P Tool/software: In current status, we have issue with USB 3.1 drive detection.
So we want to check the performance if we use the USB 3.1 re-driver, TUSB522PRGET.
Is TI teams have any resource to support USB 3.1 Gen 1 SI simulation…
Part Number: TUSB522P Tool/software: I am working on an application with adding active components on a custom board to maintain a strong signal over 7m. Currently I was thinking about using the TUSB522P redriver because I am using aUSB3.2 Type A connector…
Part Number: TUSB522P 1:
“One of our platforms implements the TI TUSB522p redriver on a USB host controller.
We would like to conduct some experiments which require removing or bypassing the redriver on the USB path.
I am reaching out to obtain…
Part Number: TUSB522P Hi team, I just want to ask a low level question to study a knowledge from you. from my understanding, Redriver is to compensate signal losses according to PCB trace and signal data rates, so when we use a redriver, just considerate…
Part Number: TUSB522P Tool/software: We are currently encountering a problem with the TI model TUSB522PIRGET when making cables. Please help us answer the reason and protocol requirements. thanks
The cable has three interfaces: Type C female, Type…
Part Number: TUSB522P Hi,
we are laying out a test board for our specialized connector. in testing the TUSB522p, we terminated both rx and tx with 50ohm resistor single-endedly to have an open eye in our testing. questions below
1. the TUSB522p's…
