Part Number: TUSB8041A Other Parts Discussed in Thread: TUSB8041 Hi
Could you help check the below TUSB8041 schematic and any need to adjust
USB3.0.pdf
Part Number: TUSB8041A Hi,
The TUSB8041A datasheet doesn't provide the information about what is the exact threshold level for detecting a valid USB VBUS voltage in the "VBUS Detect" monitor block.
Could you please provide the exact value…
Part Number: TUSB8041A Hi,
We have occur USB 3.2 Specification version 1.0 test item -
SSC - Spread Spectrum Clocking(called SSC) capability fail.
Please see below figure and regester table. Do you have any suggestion for this fail item?
Thanks!
Je…
Part Number: TUSB8041A Hi Sir,
For below TI USB Hub Test Tool, does it have above win10 version?
My customer reply they use it test TUSB8041A.
TI Hub Test Tool - User's Guide.pdf
Thanks!
Jeff
Part Number: TUSB8041A Other Parts Discussed in Thread: TPS55288 , INA230 , TPS65987D , , TAS5805M , TUSB8041 Hello,
The I2C pins 37 & 38 have an internal pull-down resistor of min 14.5k. This requires a low-impedance pull-up resistor to achieve enough high…
Part Number: TUSB8041A Other Parts Discussed in Thread: TUSB8041 , Hi Expert,
Customer replace TUSB8041IRGCR with TUSB8041ARGCR directly on the board, but it doesn't work(no signal out), while TUSB8041IRGCR can work well.
What change should do when r…
Part Number: TUSB8041A Other Parts Discussed in Thread: TUSB8041 , Hi Expert,
Could you provide the driver ability for TUS8041A and TUSB8041.
Is TUSB8041A stronger at the same condition?
Thanks,
Oliver Ou
Part Number: TUSB8041A Hi,
I try to enable the TUSB8041As SMB interface. For that, I've connected the SMBUSZ pin with 40k resistor to ground. Is this correct? I'm asking because this way, I'm seeing the TUSB8041A pulling the SMBCLK and SMBDAT line beeing…