Part Number: TVS1401 Other Parts Discussed in Thread: TEST Hi Andy,
My customer need to know the factor of Steady "State Power Dissipation" which is not shown in the datasheet. Could you please kindly advise it?
Thanks a lot.
Vincent Chen
Hi Andy,
Below is the front end diagram of RTD application with ratiometric topology, so in normal operation condition the max. voltage over TVS is about 4V and I want to know the TVS leakage current is for calculating system accuracy.
Customer doesn…
Part Number: TVS1401 It is not clear what the status of the TVS1401 is. The data sheet shows a PTVS1401 as active and the TVS1401 a preview. But, I cannot find the PTVS1401 in the TI system and no vendor has the TVS1401.
If the TVS1401 is in development…
Hello Inho,
TPD2E007 has both ESD and surge protection capabilities. If you look at the datasheet, you will see two standards listed: IEC 61000-4-2 (ESD) and IEC 61000-4-5 (surge). For surge, this device is rated to withstand up to 4.5 A of surge current…
hi andy,
i feel that only TVS1401 will be suitable for my application because of 20.5V clamp voltage. i feel the rest are not suitable. please confirm.
https://www.ti.com/lit/ds/symlink/tvs1401.pdf?ts=1592540251961&ref_url=https%253A%252F%252Fwww.ti…
Other Parts Discussed in Thread: TVS1401 Hi Team,
Is there a competitive device we have in our portfolio to compete with the PESD0402-140?
Thanks,
Jared
Part Number: TVS3301 Other Parts Discussed in Thread: TVS1401 , Hello
The below is from package outline page in TVS3301 and TVS1401 datasheet.
Which is valid for this DIM A, OPT1 or OPT2 ?
Regards, Oba
Part Number: TVS3301 Other Parts Discussed in Thread: TVS1401 , Hello
My customer is asking some additional package information of TVS1401 and TVS3301.
Q1)
Is “Q1” in the below figure the same as “DIM A”?
Q2)
Could you please…
Part Number: TVS3301 Other Parts Discussed in Thread: TVS1401 , Hello,
I have a question for thermal pad of TVS3301 and TVS1401.
Both datasheets say that the thermal pad must be floating. Does it mean the thermal pad can be left not soldering to anywhere…
Dear Cameron,
thank you for the information :)
Regarding the TVS1400 and TVS1401, we want this to use on FPDLink III interface after the PoC filter. Is this ok?
https://e2e.ti.com/support/interface/f/138/t/818570
Best Regards,
David.