Part Number: TXB0104-Q1 Hi expert,
The rates in the datasheet of TXB0104-Q1 are all marked in MBPS, but many customers use clock signals.
For example, how many MHZ clock frequency can 100Mbps correspond to?
Thanks
Xiaoxiang
Part Number: TXB0104-Q1 Hi Team,
This Query is regarding TXB0104-Q1 Level Translator,
Q)What is the default state of input/output pins of Port A and Port B If VCCA and VCCB is not supplied?
Q)Once VCCA and VCCB is supplied, does all the Input/Output…
Part Number: TXB0104-Q1 Other Parts Discussed in Thread: TXS0104E-Q1 , TXU0304-Q1 , TXU0104-Q1 , TXU0204-Q1 , TXB0104 , TXS0104E
Hi team,
As you can see, we have the following connection method. We used TXB0104-Q1.
There are no pull-up and pull…
Part Number: TXB0104-Q1 Tool/software: Hello, My customer is observing some overshoot and undershoot at VI and VO at ports and they are exceeding the Absolute Maximum Ratings of Vi and Vo for short period. VI and VO could exceed for just short period…
Part Number: TXB0104-Q1 Tool/software: Hi Team,
My customer is reviewing it as below connection.
VCCA = 1.8V
OE = 1.8V PU to VCCA (or 3.3V control by MCU GPIO)
VCCB = 3.3V
1. Any recommendation for power on sequence?
2. VCCB=3.3V always…
Part Number: TXB0104-Q1 Tool/software: Hello,
I am trying to determine what will happen when the inputs or outputs on one side of the TXB0104-Q1 are subjected to over-voltage (up to 36V). I do not expect the part to remain undamaged, but I would like…
Part Number: TXB0104-Q1 Other Parts Discussed in Thread: TXB0104 , TXU0304-Q1 , TIDA-00296 Hi BU team
My customer reported txb0104-Q1 didn't always output any waveform after powered-up.
The schematic is shown in below screenshot. The DSP send 12.28MHz…
Part Number: TXB0104-Q1 Other Parts Discussed in Thread: TXU0304-Q1 TXB0104-Q1 is used for I2S level conversion in my projiect, 1.8V to 3.3V;
How to place the terminal resistor on the original I2S signal?
Should it be placed near the SOC end or near…
Part Number: TXB0104-Q1 Tool/software: Hi TI Expert,
Quite confused about the package info of the TXB0104QRUTRQ1 .
Does that means we extend the pad to the package side like wettable flank?
Like we have conductive pad on each side so it's easier…
Hi Cheng,
CHENG KAI said: And another question is can I change the pull up Res ro be 50K that make the I2C work?
You may try but 50 K may not suffice for I2C.
CHENG KAI said: Would you please recommend the P2P level shift IC for replace the…
