Part Number: TXB0304 Tool/software: Hi team,
We are considering level conversion for the QSPI signal (1.2V ⇔ 1.8V). When SCK = 25MHz, is the TXB0304 suitable for level conversion of D[3:0]?
Best regards,
Part Number: TXB0304 Other Parts Discussed in Thread: TMUX1574 , TXU0304 , TXB0604 Hi TI Team,
I have some questions regarding the TXB0304 / TXB0304N. Could this device be used as a repeater for SPI or eSPI applications?
According to the datasheet…
Part Number: TXB0304 Tool/software: Hello team,
What is the current drive strength of TXB0304?
If it is varied by VCC, then could you give me the number when VCC = 1.8V and 3.3V?
Best Regards, Kei Kuwahara
Part Number: TXB0304 Other Parts Discussed in Thread: SN74AXC4T774 Tool/software: Hey, i want to use the txb0304 for jtag interface to connect my jtag header to i.mx93 processor. I use shifter from 3.3v to 1.8v
The outputs from the LS are TDI, TCK and…
Part Number: TXB0304 Other Parts Discussed in Thread: TXB0302 , TXB0106 Tool/software: Hello,
In our design, we need to perform level translation on a QSPI signals between an FPGA (1.2V) and QSPI Nand Flash (1.8V).
We would like to optimize the…
Part Number: TXB0304 Tool/software:
In the Figure I have marked two red boxes, one for pin A4 and one for B4. Here in both the pins the description is shown differently. For A4 it is mentioned as Input/Output 4 and for B4 it is mentioned as Input/Output…
Part Number: TXB0304
Hi, Support Team
We will use TXB0304 as below chart, have any concern?
if any suggestion, Please advise me.
Thanks,
Best regards,
Lawrence
Part Number: TXB0304 Tool/software: Hi Team, We are using this part in our design , need to know about the calculation of power consumption for this part Please help us to calculate
Part Number: TXB0304 Hi,
I encounter a issue about current, the schematic is as follows,
Story:
Step 1. When the voltage of VDD_EXT changes from 1.8V to 0V, the current of TXBN0304 will be as high as 400uA(20pcs out of 100pcs chips will have this…
