Other Parts Discussed in Thread: UCC27536 I’m wondering if I can use a gate driver (Texas Instruments, UCC27536) to convert logic level data to 27 Volt logic level data? There’s some capacitance I need to drive (100nF) but I believe I should be able to…
Part Number: ISO7710 Other Parts Discussed in Thread: UCC27536 , , PSPICE-FOR-TI Hello E2E,
Please help our customer wth the error encountered in using our spice models. Here is the full query:
I use ISO7710 and UCC27536 in one design both of them…
Part Number: UCC27533 Other Parts Discussed in Thread: UCC27536 Hi,
in datasheet true table, there are 'float' and 'x'.
i think float represent 'leave this pin unconnected', right?
what's the 'x' meaning?
Other Parts Discussed in Thread: UCC27624 , UCC27536 , TLV1704 , ISO1212 I explained our detailed requirement.
1) I have 4 input signal are logic range has 5V (Input) that in to 24V logic (output) conversion required.
2) Other 4 input signal are logic…
Hi Eagle,
UCC27536 is a good alternative but you can also control drive current by choice of Vdd supply and also increasing your gate resistor which would reduce drive current from the driver IC. Though the driver is capable of 2.5A current, it will…
Hi Don,
Thanks for the welcome. I've actually trolled here on and off for years but this is my first cry in the darkness. There actually appears to be a lot of light here!
That's very good news about my hoped for usage of the UCC23513, especially…
Hi Sailesh,
The UCC27531 is a 2.5A/5A single channel IGBT/FET driver that is suitable for your application.
Also available are the UCC27532 and the UCC27536 drivers.
Please check out the UCC29950 which is a combination PFC and LLC combination type…
Hey Chase,
Thank you for reaching out to TI with your questions regarding the UCC27519A-Q1.
Please see the attached Schematic Review Template for reference.
3364.UCC27518_9 Schematic Review Template.xlsx
Here are a few notes:
1. The EN pin can…
A list of schematic review templates for many of our devices are available below! These templates are meant to be used in conjunction with our datasheets to help designers review their schematics.
UCC27516 and UCC27517 Schematic Review Template
…
Hi Rogers,
Thanks for reaching out on E2E!
Please see the following feedback:
IN: Input looks good. If there is a lot of noise on your input waveforms, consider adding an RC filter with a TC of no greater than 20 ns.
EN: I notice that the label…
