You need to switch to Studio. The two applications fissioned some time ago, so the UCD updates to the Designer stopped at that time. It is only for a different set of parts.
Hi Pedrhom,
To conclude, how should I deal with the data from different channels to get the correct angle estimation after collecting the raw data from IWR6843ISK DCA1000EVM? Should I reverse the sequence like mmWave studio and the Matlab example (…
Hi
We did not connect the enable pin of Vr to UCD90160A, only designed as a monitoring function on this power rail.
I think the fault response function only use for the power rail, which needs to control the power sequence by UCD. Am I correct?
…
Part Number: TPLD1201-DGS-EVM Tool/software: Hi,
I think that IO9 output H pulse during startup EVM. Is it true?
Both DFFs has L intial state, so will start L outputs for IO6 and IO7.
But after clicking [CONFIGURE] at the InterConnect Studio,…
The normal way to design with the UCD is to use an EVM or your own board, along with CCS 6.2 and the Fusion Digital Power Studio. Fusion Digital Power Studio includes the UCD3xxx Device GUI, which is useful for lower level programming task. The Fusion…
Part Number: UCD3138OL64EVM-031 Other Parts Discussed in Thread: UCD3138
Hi,
I have a UCD3138OL64EVM-031 board with me.
I am trying to download available UCD3138 practice lab firmware codes (downloaded from: https://www.ti.com/tool/UCD-TRAINING…
Hi Sean,
Thank you for your fast comment.
1. The DPWM turn-off sequence depends on the F/W which is coded by customer. Is my understanding correct?
2.Then I believe I could also find the this turn-off sequence code somewhere in the UCD3138AEVM…
Also, If I try to program 2nd time immediately, I get "Programming: Priority Sequence already in progress".
I could able to program the above .SREC file when I selected "UNSEAL FULL ACCESS" but with error (I couldn't capture the screenshot of that…
Hi,
Is this the new board you power on for the first time?
First, you need establish the connection between UCD and GUI. Unplug SAA, then plug SAA. Check if UCD is powered on. Then Open Fusion DIgital POwer Studio. Scan the device in Program mode…
Hi
I already replied your 2nd question.
Please refer section 9.5 or 9.6 to update the configuration data
5488.Configuration Programming of UCD Devices.pdf
Regards
Yihe
