Other Parts Discussed in Thread: WL1801MOD , WL1801 Hello TI,
My customer is planning on using the WL1801MOD in an upcoming design.
They do not plan on using an OS on the Microblaze processor in the FPGA they're going to use.
Is this a problem? Can…
Other Parts Discussed in Thread: WL1837MOD , WL1801 , WL1831 Hello,
I'm facing the same trouble... beacon lost. very often (I’ve been testing) with different access points... seems to happen on all the access points I’ve been testing.
Distance…
Other Parts Discussed in Thread: WL1801 , AM3352 Background:
The stack for a WL1801 is being hosted on an AM3352. During a system idle mode when no data is being sent, the WiLink must maintain connections to any devices.
Problem description:
To extend standby…
Hello Neha,
Please make sure the hardware is all fine (all connections are OK, overshoot, undershoot, frequency, signal integrity, setup, hold, etc.). I would think it is most likely a HW issue although I have not run into this same specific problem…
Other Parts Discussed in Thread: WL1801 Hi ,
According to WL18xx_WLAN_Hardware_Design_Guide ,a 10K pull up on IRQ pin will enable Debug mode. So i would like to know if we are using Debug mode any other functionality will have impact.
Thanks
Naigin Ka…
Other Parts Discussed in Thread: WL1801 Hi all,
I've previously had support from this forum in getting the WL1801 up and working with a Zynq 7000 processor running Linux, but recently I've noticed some weird behaviour when attempting to use the WiFi and…
Other Parts Discussed in Thread: AM3354 We are looking at using a wilink8 based wifi module, attached to our am3354 which has a real time clock. Ideally, we would like to avoid having a separate 32khz oscillator, and to just use the RTC oscillator that…
Other Parts Discussed in Thread: WL1801 Hi,
We've designed a custom board around the Xilinx Zynq processor including the WL1801. The WL1801 is connected to the Zynq through the SDIO interface. We're trying to bring up the device and not having great success…
